bing tracking image

Filter Questions and Answers:

reset filter

Expert Answers about Chevrolet Chevelle


  • Fit of Air Lift 1000 Drag Bags AL60844 on 1969 Chevrolet Chevelle
  • The AirLift 1000 Drag Bags for Rear Coil Springs # AL60844 are a confirmed fit on your 2WD 1969 Chevrolet Chevelle. These are designed to pre-load the rear suspension for better traction and to keep the car level at launch. They may not totally eliminate wheel hop but they will certainly improve off-the-line performance. These bags are not offered in any color other than red. The kit includes everything needed to install the bags, including manual inflation valves. You can add a compressor...
    view full answer...

  • Electric Radiator Fan Less Than 2-3/4" Wide for 1967 Chevrolet Chevelle SS
  • I do have a solution, but unfortunately all of the higher CFM fans are too wide for the space you have. The highest CFM is going to be 2,500 to be able to match that space. We have the following options available which all have a width of 2-5/8" and 2,500 CFM: -Lo-Profile 12-1/8" Dual Electric Radiator Fan - Nylon Shroud - Puller - 2,500 CFM # FLX420 -Lo-Profile 12-1/8" Dual Electric Radiator Fan w Controller - Nylon Shroud - Puller - 2,500 CFM # FLX410 -Lo-Profile 12-1/8" Dual Electric...
    view full answer...

  • MagnaFlow Exhaust Recommendations for a 1967 Chevelle Super Sport
  • According to MagnaFlow, the Stainless Steel Crossmember-Back Exhaust System, # MF15897, will fit your 1967 Chevelle SS. This kit is a cross member back exhaust kit. My contact at MagnaFlow stated that you would need to fabricate or have a shop fabricate the section that goes from the cross member forward to the manifold or headers. Part # MF15897 is a 3 inch kit but there is also a 2-1/2 inch kit, # MF15893. I have included a link to the installation details for both kits for you to view.
    view full answer...

  • Can the Air Lift 1000 Drag Bags Be Inflated Separately?
  • The Air Lift 1000 Drag Bags for Coil Springs item # AL60844 comes with everything you need to set the air bags up for dual path or single path. Dual path will allow you to adjust the PSI individually using separate valves.
    view full answer...

  • Can the Deka Battery Isolator DW08770 Be Used On a Boat
  • Yes, the Deka Battery Isolator part # DW08770 can be used on a boat to separate the starter and auxiliary battery but you would need to mount it in a location that is least likely to get wet, like in a battery box, the NOCO Snap-Top Battery Box with Strap part # 329-HM318BKS.
    view full answer...