The standard plate to put the VIN sticker of the Malone Microsport Lowbed Trailer Model # MPG460G is on the frame of the trailer. Since the tongue of this trailer is removable I put it further back than that on the portion of the frame that splits off to either side. I'd go with on the inside of the frame rail in that section and you'd be good. view full answer...
The Curt Trailer Hitch Receiver # C49CR does not require the removal of the bottom bracket attachment during installation. Your description of the installation is also accurate. view full answer...
The Curt Trailer Hitch Receiver part # C49CR is an excellent option for a 2020 Mazda CX-30. It has a hidden design which means the receiver tube opening will be tucked up right under the rear bumper which will make for not only the best aesthetics but also the best possible ground clearance. I don't have any exact measurements of this yet but we do have an install photo which as you can see should provide enough ground clearance to not cause any issues. There isn't going to be another option... view full answer...
If I am reading this correctly, you want to know where to attach the cable to lock your bikes to the Thule Helium Pro 2 Bike Rack - 1-1/4" and 2" Hitches - Tilting - Aluminum, part # TH9042PRO. The cable attaches in a slot on the left arm of the hitch bike rack. The lock core is in the front of that arm.
I have attached a picture for reference below. view full answer...
No, wiring the Tekonsha T-One Vehicle Wiring Harness # TK67FR you have to the battery of your 2021 Mazda CX-30 will not cause the battery to go dead due to it only powering the trailer lights when the vehicle is turned on.
You will however have to wire the kit to the battery with the included inline fuse to protect the factory wiring on your vehicle from damage, and to keep from voiding the warranty of your harness.
I included a video of the # TK67FR being installed for you to take... view full answer...
The Curt Trailer Hitch Receiver part # C49CR which is a fit for a 2021 Mazda CX-30 does not require any drilling for installation. You do need to enlarge access holes which basically means opening up pre-existing holes slightly more so the hardware can fit through. view full answer...