bing tracking image

Filter Questions and Answers:

reset filter

Expert Answers about Toyota


  • Recommended Roof Cargo Carrier for a 2018 Toyota RAV4
  • The Curt Roof Rack for Raised Side Rails # C18118 you have currently will work fine with any roof cargo carrier you choose to use. These are just standard aero bars which will work with pretty much anything. That being said, the cargo box you ultimately choose will depend on how much space you're needing. For example, the Thule Motion XT Rooftop Cargo Box # TH629706 is a great option that has 16 cubic feet of cargo space, and a 165 lb weight capacity.
    view full answer...

  • Recommended Kayak Carrier for a 2023 Toyota Corolla Cross Hybrid
  • I actually checked out the owner's manual for your 2023 Corolla Cross and it states that there is actually a 165 lb capacity, so that should be more than enough to carry a couple of kayaks. To carry your kayaks, I recommend checking out the Yakima JayLow Kayak Roof Rack w/ Tie-Downs # Y04073. This carrier can carry up to two kayaks (in the vertical position, or 1 kayak in the J-style position), a maximum single kayak capacity of 80 lbs or a dual kayak capacity of 120 lbs, and will easily...
    view full answer...

  • Does the EcoHitch Hidden Trailer Hitch item # EH53VR Fit a 2017 Toyota Prius Eco?
  • Yes, it will. I checked with EcoHitch and I can confirm that their Hidden Trailer Hitch item # EH53VR will work with the Eco model 2017 Prius. I have linked an installation video below so you can see how to get this hitch set up. If you are planning on towing you will also need a wiring harness item # C56353 and a ball mount kit item # C45534. I also recommend using the No-Drill Mount Bracket item # 18136 and the item # C42CR to secure the 4-way connector to your hitch. This will put...
    view full answer...

  • Difference Between Truxedo Truxport and Lo Pro QT Tonneau for 2015 Toyota Tacoma
  • The Lo Pro QT part # TX556901 auto tensions, uses cam buckle installation clamps, uses a one-finger quick-release latch release for the cover, and sits between the bed rails. Whereas, the Truxport # TX256801 requires manual tension adjustment, has a slightly more involved release system, will require tools to install the installation clamps, and sits on top of the bed rails. Both of which have been confirmed as a fit for your 2015 Toyota Tacoma with a 6 foot bed.
    view full answer...

  • Using a Thule Hullavator Kayak Carrier on a 2014 Toyota FJ Cruiser with Factory Roof Rack
  • I will be happy to help you out. The Thule Hullavator kayak carrier, # TH898, needs to be mounted on crossbars that extend beyond the side rails or foot pack. It will not fit any other way. So to add compatible crossbars to your 2014 Toyota FJ Cruiser that has factory crossbars you can use the Thule rack using parts # TH712400 and # TH710401. These bars mount to the side rails and also include locks to deter theft. Enough of the bars will be sticking out each end to use the Hullavator. Another...
    view full answer...

  • Will a Trailer Hitch Interfere with Removal of Spare Tire on a 2016 Toyota Highlander
  • For Curt trailer hitch # C13200 they state that on the 2016 Toyota Highlander "Vehicles with a full size spare stored under the vehicle will not be able to store spare underneath after hitch installation." But if you have the mini spare (smaller than the tire size on the vehicle) then there won't be a problem. You may find that you will need to angle the spare tire when lowering or replacing it. The same goes for Draw-Tite hitch # DT65MR. They also have a note stating "When stowing the...
    view full answer...

  • Is It OK For Super Springs SumoSprings to Touch Frame of 2005 Toyota Tacoma when Truck is Unloaded
  • Typically, you do want a bit of space between the spring and the truck frame when the truck is unloaded. However, if your Super Springs SumoSpings # SSR-610-40 touch the frame of your 2005 Toyota Tacoma when it is unloaded it will be okay. The only thing you may notice is a bit stiffer of a ride since the springs will engage more quickly once the truck is loaded. From the install photos taken when we installed these springs on a 2007 Tacoma, it appears that truck had very little to no...
    view full answer...

  • Trailer Hitch Fits for 2017 Toyota Sienna
  • Sometimes a trailer hitch will fit multiple model years of a vehicle but other times one model year's difference can mean it won't. Curt Class II hitch # C12065 fits various versions of the 2004 through 2016 Toyota Sienna. However this hitch is not a confirmed fit on the 2017 model year. For the 2017, the 1-1/4-inch Class II hitch that is confirmed to fit is Draw-Tite # 36513. Curt offers only a 2-inch Class III hitch for the 2017 Sienna, part # C13105. I confirmed this directly with...
    view full answer...

  • Using Heavy Duty Modulite, Part # 119190 on 2008 Toyota Rav 4
  • If you do not care to use the Tow Ready Harness, part # 118412 that plugs in to the connectors behind the taillight assemblies, you can certainly use the Heavy Duty Modulite Wiring Harness, part # C59496. The Heavy Duty Modulite Wiring Harness is not vehicle specific. We have an installation video that you might find helpful, I will provide a link below. The video shows the Modulite being installed on a different vehicle, but the procedure for locating the correct circuits and the connections...
    view full answer...

  • Rooftop Cargo Basket 59504 Compatibility with a 2008 Toyota FJ Cruiser
  • I went out and measured an FJ in our lot, and it looks like your cross bars should be 2-5/8 inches wide. The # 59504 roof rack will fit factory crossbars up to 3-1/4 inches wide, so it would be a great fit on your 2008 Toyota FJ Cruiser.
    view full answer...

  • Will Yakima Spare Ride on 2008 Toyota RAV 4 Damage Door Hinges if Door is Opened With Bikes In Place
  • To avoid damage, Yakima recommends removing the bikes from the rack before opening the tail gate. Following this advice will ensure that your door and hinges will remain damage free. The weight of the rack itself will not hurt anything, and would allow the door to open and close without any worry of damage. Adding the weight of the bikes into the equation leaves open the possibility of the hinges being damaged.
    view full answer...

  • Curt Fifth Wheel Bracket Recommendation for a 2012 Toyota Tundra
  • Yes, the Curt Custom Fifth Wheel Bracket Kit # C16448 that you referenced would be the correct bracket kit for your 2012 Toyota Tundra with a 6-1/2 foot bed to install the Curt Slider hitch from your previous vehicle. If you need the fifth wheel rails also you would want part # C16468-204. I attached installation instructions for the # C16448 for you to check out also.
    view full answer...

  • Do Yakima Core Bars fit Thule Tracks on Leer Cap
  • A Yakima rack with CoreBars is compatible with the Thule tracks on the Leer cap of your 2016 Toyota Tacoma. To install the rack, you would need the following parts: Two of the Landing Pad 1 for Yakima Control Towers # Y00221 SkyLine Towers for Yakima Crossbars # Y53TR The Yakima CoreBars you need would depend on the width of your Leer cap; your options are Yakima CoreBar Crossbars 50" Long # Y00421 Yakima CoreBar Crossbars 60" Long # Y00422 Yakima CoreBar Crossbars 70" Long # Y00423 I...
    view full answer...

  • Does Anti-Rattle Hitch Lock and Cable Lock # HRLHPTC Fit 1-1/4" and 2" Trailer Hitches
  • Anti-Rattle Hitch Lock and Cable Lock # HRLHPTC fits specific Hollywood Rack bike racks that do indeed fit both 1-1/4 inch and 2 inch hitch receivers. So if you have a Hollywood Racks Commuter, Traveler, or Sport Rider bike rack then this lock will work for you.
    view full answer...

  • Is Pigtail of 22117 Compatible with Hopkins 7- and 4-Way Connector
  • The two have never been tested together and are from different manufacturers, so with that said, from what I can see it looks like the Tekonsha OEM Replacement Vehicle Wiring Harness with Brake Controller Adapter # 22117 is compatible with the 7- and 4-Pole Trailer Connector Socket # HM40975. Both 7-way on the Tekonsha has a US Car Connector which means it will plug into the Hopkins connector. I do want to note part # 22117 is compatible with certain model year Toyota Tacomas, which the...
    view full answer...

  • Could Trailer Hitch Installed on 2018 Toyota RAV4 Be Used as Jacking Point
  • Hitches actually work great as jacking points generally as they are reinforced steel beams that attach directly to the vehicle frame. I wouldn't think twice about using a hitch installed on your 2018 Toyota RAV4 like the EcoHitch # 306-X7219 you referenced if ever needed. For you vehicle it has not been an issue we've seen from our customers or manufacturers as well.
    view full answer...

  • Sway Control Bracket for Curt Friction Sway Control Bar # 17200
  • Yes, the Reese Sway-Control Bracket # RP26003 that you referenced will work perfectly with your Curt Friction Sway Control Bar # 17200. This is actually the exact bracket we recommend using with the Curt Bar since Curt does not have one of their own. This will simply mount to your ball mount to provide a bracket for the Sway Control bar without the need for any welding. I have attached a short video review that you can check out as well.
    view full answer...

  • Where to Find Stoplight Switch When Installing 2008 Toyota FJ Cruiser
  • Sounds like you are looking for help finding where the red wire of the brake controller you are trying to install in your 2008 Toyota FJ Cruiser needs to run to. This circuit needs to be connected to a circuit that only sees voltage when the brakes are applied. When we installed a brake controller in a 2008 FJ Cruiser we found that the wire needed was green with a yellow stripe of the wires that run to the brake pedal switch. See attached part 2 install video around the 8:45 second mark.
    view full answer...

  • Is It Better To Install the Long Red Conspicuity Reflective Tape In Colder or Warmer Weather
  • There is not a recommended temperature range for installing the 7" Long White/ 11" Long Red Conspicuity Reflective Tape part # RE21T although warmer would be better as that would then help the adhesive stick better. In regards to prep work, just make sure there is no dirt on the surface but a quick wipe down with a cloth or soap/water should be all that is needed.
    view full answer...

  • Rubber Bed Mat for 2019 Toyota Tacoma with 5 Foot Bed and Factory Bedliner
  • Since you have the short 5 foot bed on your 2019 Toyota Tacoma your best option for a rubber bed mat is with the Westin Custom Fit # 50-6315. The DeeZee model that you referenced is for 6 foot beds so it is too large and would require significant modifications. There is not a DeeZee bed mat available for the 5 foot bed on your Tacoma. As long as the factory bed liner on your truck isn't too thick you shouldn't need to trim anything for the mat to fit well. Since there are some factory...
    view full answer...