At this time the Classic Accessories RV Captain Seat Cover # CA80112 is the only seat cover we carry. This cover is designed to fit seats 23-1/2" wide with backs up to 23-1/2" tall and arm rests 17" long. You will need to measure your seats to verify if they will fit. view full answer...
To fit your 41 foot long Class A Newmar Ventana I recommend using the Adco SFS AquaShed RV Cover for Class A Motorhome - Up to 43' Long - Gray # 290-52208, which is a great solution to keep your Class A coach protected from the elements. The SFS AquaShed has a triple layer fabric that beads water to help keep your coach protected and the built in air vents help keep wind from damaging the cover. view full answer...
You will not have any problems fitting the Demco SBS Coach Air Kit for Air Force One Supplemental Braking System # SM99627 to your 2015 Newmar Ventana 3635 with the Freightliner chassis. I have included images from the instructions showing the air lines to connect to on your Freightliner chassis. view full answer...
We have a great option.
It's the Hollywood Rack Sprot Rider SE2 with Cargo Carrier, part # HR1450Z-85. This will allow you to carry 2 bikes at 50 lbs per bike and 100 lbs of cargo. It fits 2" receivers and has an anti-rattle knob to reduce sway.
I've linked to a video review of this combo for you to look at. view full answer...
The Thomas Payne Swivel Glider RV Recliner with Heated Seat part # 195-000029 measures 29-1/2" wide x 35" deep x 41" tall so if you have this much space it will fit. view full answer...
For aluminum sensors to use with the TireMinder i10 TPMS for RVs # TM56FR the part # TM-2ALUM would be what you'd need for a pair of these sensors. These are needed for if your valve stems are aluminum like it sounds like they are. view full answer...
For your Newmar Bay Star Sport 2702, I'd recommend the Sumo Springs Maxim # SSR-187-40-1 for the rear and the Rebel # SSF-170-40-2 for the front. The Rebel springs are specifically designed for use on a steer axle, while the Maxim is designed for the drive axle. Sumo Springs do a great job of helping to reduce shocks and bumps, and they also help minimize sway and body roll.
I've linked to some installation videos that you might find helpful. view full answer...
It's not overly critical no, ideally you'd want your Roadmaster Rear Anti-Sway Bar # RM-1139-145 to be as level as possible so if the lower hole is the closest to level then that would be the one you need to use. There are also two holes in the frame bracket hangar that can be used for additional adjustments if need be.
I've included the optimal angle for install for you to reference as well. view full answer...
Going with a heavy duty Sumo Spring like part # SSR-187-54-1 is going to make the ride quality a lot better on your 2019 Newmar. I would always go with the stronger option because when you hit pot holes or go over curbs the ride quality is going to improve tremendously.
Most people add sway bars as well. A sway bar makes the motorhome feel more solid while traveling down a windy road or while changing lanes. Part # RM-1139-149 is the correct rear sway bar for your application. Part #... view full answer...
Yes you can use the Roadmaster Tow Dolly # RM-2050-1 to tow your FWD 2017 Hyundai Santa Fe Sport. This doesn't come with a trailer wiring plug so you'd also need the # PK12706. view full answer...
We have spoken with Fan-tastic Vent in the past with this exact question and the Vent cover part # FVU1500WH would be the cover you'd want. The fan lid does open to 11-1/2 inches tall and the cover is 10- 1/4 inches so the fan lid does not completely open with the cover attach but Fan-tastic does guarantee the fan will still work to it's fully intended speed. The fan lid not extending all of the way does not affect the motor or wear it down. The fan is still open enough to get the proper... view full answer...
Yes it is possible to use the Roadmaster Dual Hitch Receiver Adapter part # RM-077-6 to flat tow your Gladiator and use the Hollywood Racks Sport Rider SE Bike Rack for 2 Electric Bikes part # HLY84FR at the same time. Check out the video my buddy Rob did showing exactly what you want to do.
This does not included a pin and clip so if you do not have it pick up the Pin and Clip For Class III, IV and V Trailer Hitch Receivers part # PC3.
Since you are adding an additional connection point... view full answer...
Your 2015 Newmar Canyon Star Model 3610 is built on a Ford F-53 chassis which is plagued with handling issues.
The biggest improvement you can make is a rear sway bar. For that you would want the part # 1139-144. Next you would want to go with a front sway bar as that will make the next biggest improvement. For that you would want part # RM-1139-148. view full answer...
I reached out to my tech contact at Roadmaster and the shock installation of your Steering Stabilizer # RM-RBK13-RSSA does not have a proper orientation. It can be installed with either end of the shock installed to either bracket. He said whichever orientation provides better clearance from other parts is their recommendation. view full answer...
I may have a solution for you but there are no custom fit front mount trailer hitches available for the 2011-2012 ford F-53 Chassis. The Curt Adjustable Width Trailer Hitch Receiver for RVs part # C13702 or the Curt Adjustable Width 2" drop Trailer Hitch Receiver for RVs part # C13701 would be the options to check out.
I do not have specific data for the overhang you have past the frame on your 2012 Newmar Canyon Star but these would be the only options I have that would come close to... view full answer...
I was able to contact the manufacturer of SnapRing TireSavers Tire Covers # ST7002WH and these are available only in black and white. There are tan options available like Adco Tyre Gard RV Wheel Covers - Qty 4 # 290-3962 view full answer...
I recommend adding front and rear SumoSprings to your RV. For the front kit you would need # SSF-173-40-2 and for the rear use # SSR-187-54-1. These will help to keep your RV from swaying in higher winds and when cornering. view full answer...
I have a solution for you.
Rock Tamers Heavy-Duty, Adjustable Mud Flap System for 2" Hitches - Matte Black # ERT00108.
Rock Screen for Rock Tamers Heavy-Duty Adjustable Mud Flap System # RT37FR.
We do not have custom fit rock tamers with cut outs for mufflers. However we do have the Rock Tamer Heavy-Duty system. It can expand up to 96 inches and is 24 inches tall.
You can pair it with the Rock Screen for optimal protection from road debris that can be kicked up by your RV.
Make sure... view full answer...