Expert Answers about Itasca

• Troubleshooting Motor On Kwikee Steps Continuing To Run After Steps Are Fully Opened Or Closed
• I reached out to my contact at Lippert and the issue you are describing on the Kwikee Steps on your 2013 Itasca Meridian 34B is a tell tale sign of a bad controller. The cause is the controller is not detecting the amp draw of the motor when the steps are fully opened/closed and is causing the motor to keep running after the step is fully opened/closed. The Controller # LC363980 you were looking at is a replacement for Kwikee Revolution Steps. If that is not what you have on your Motorhome...
  view full answer...


• Kwikee Steps On Itasca Navion IQ Will Not Stop Once Retracted
• The issue with the Kwikee Steps on your Itasca Navion IQ is actually the motor, not the controller. The problem with the motor is that it is not arching out which is then what sends the signal for the steps to shut off. Therefore, the Replacement Motor for Kwikee Electric RV Steps part # LC379147 is what you need to fix your steps based on those symptoms. However, if something goes wrong down the line we have the controller as well with the Replacement Control Unit for Kwikee Electric RV...
  view full answer...


• One Leg On Lippert Ground Control Not Touching After Screen Shows Successful
• It sounds like you just need to reset the zero point. In order to do this you will need to follow the steps I have attached for you below and in the photo. If this does not fix your issue then please just let me know and I will see if we have any other actions for you to preform. 1. Manually run the jacks to level the unit. This is best achieved by placing a level in the center of the unit and leveling it both front to back and then side to side. 2. Once the unit is level, turn off the...
  view full answer...


• How To Clear Error Codes On An Advent Air RV Air Conditioner System Thermostat
• To reset the thermostat of your Advent Air RV Air Conditioner System # ADV64FR you'll need to complete the following steps: Start with Thermostat in Off mode. Press and hold both the mode and fan button at the same time in the Off mode. Continue to press both buttons and press the power button and then release all 3 buttons. The LCD will flash On/Off while pressing all 3 buttons. Once the buttons are released the LCD will turn off and the system has been reset to factory settings and should...
  view full answer...


• Troubleshooting An E5 Error Code On An Advent Air RV Air Conditioner System
• An E5 error code simply means there's a communication error between the relay box # PXXACRG12RB and the thermostat. If you're hooking it directly to the relay box without any extra wire and it's wired correctly and you're still getting the E5 error then either the relay box or thermostat is defective and needs to be replaced. Just to make sure you have it wired correctly I've listed the wire colors from the relay box and their connections on the thermostat below: Blue: A Purple: B Green:...
  view full answer...


• What Does the Return Leveler for Service Error On the Lippert Ground Control Mean
• The Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System part # LC358590 when meet with an error can display a "Return Leveler for Service" message. This is a general code therefore I don't have any specific troubleshooting steps for this. That said, all you need to do to clear the code is press the retract button and enter button simultaneously, holding for about 3 seconds. If the error code then reappears you will need to take the system in for service as instructed by the...
  view full answer...