Expert Answers about Itasca
- Determining The Correct Converter Charger For A 2014 Itasca Suncruiser Motorhome
- When it comes to choosing the correct size converter charger you'll simply need 10% of the total amp hour rating of your battery bank up to the max amperage that the battery can handle, which is typically listed on the battery. In your case your battery bank is 270 amp hours (if wired in parallel) so you would need a minimum 27 amp charger.
The Progressive Dynamics # PD9245C has a 45 amp rating so it would be sufficient. If you wanted to go with a higher amperage charger to recharge your...
view full answer... - Steering Stabilizer Recommendation for 2011 Itasca Ellipse
- Yes, the Roadmaster Reflex Steering Stabilizer part # RM-RBK18-RSSA that you referenced is confirmed as a fit for your 2011 Itasca Ellipse Motorhome as long as it has air suspension and a solid front axle. I attached an install video for this kit for you to check out as well. The motorhome is different from what you have but the chassis is the same.
view full answer... - Is Gustafson RV Vanity Light LED or Incandescent
- You were looking at the Gustafson RV Vanity Light, part # 277-000324. The bulbs that are included are incandescent but can be replaced with # DI48VR LED bulbs.
view full answer... - Replacement Motor For a Fan-Tastic Vent Model XW8100DM
- The older Fan-Tastic Vent model XW8100DM has been discontinued and there is not a motor only replacement available. But the Replacement Fan Motor Assembly Kit for Fan-Tastic Vent Roof Vent Fans # FVK8017-00 will work as a replacement for your Fan-Tastic Vent model XW8100DM.
view full answer... - One Leg On Lippert Ground Control Not Touching After Screen Shows Successful
- It sounds like you just need to reset the zero point. In order to do this you will need to follow the steps I have attached for you below and in the photo. If this does not fix your issue then please just let me know and I will see if we have any other actions for you to preform.
1. Manually run the jacks to level the unit. This is best achieved by placing a level in the center of the unit and leveling it both front to back and then side to side.
2. Once the unit is level, turn off the...
view full answer... - Steering Stabilizer for 2008 Itasca Sunova Motorhome on Ford F53 Chassis
- Your Ford F-53 chassis has a 20,500 GVWR, which means that the # RM-RBK22-RSSA would be the correct steering stabilizer for your 2008 Itasca Sunova Motorhome. I've linked to a product description and an install video.
The # RM-RBK14-RSSA isn't a fit for your chassis.
view full answer... - Can Trailer Handrail # AC-554 Install on 2007 Sunova
- The hand rail part # AC-544 is designed for exactly what you are looking to do. It can attach to your RV and provide a hand rail when needed. The style of your steps would not matter as it will operate independently of that.
view full answer... - Diameter of Output Shaft on the MaxxAir Mini Deluxe Trailer Roof Vent
- The output shaft on the fan motor within the MaxxAir Mini Deluxe Trailer Roof Vent part # MA00-03851 has a d-shape and is 1/8" diameter.
view full answer... - Replacement Step Motor for Kwikee Steps on 2013 Itasca Sunova RV
- I would also take a look at the actual gear that's being used to drive your steps up and down isn't damaged, but it's possible that when replacing your old motor you will need to also replace the gear box and linkage assembly. If you've got a motor with the LCI part number 336043 then the Replacement Motor for Kwikee Electric RV Steps # LC379147 will work for you. The correct gearbox and linkage for this motor is the Replacement Gear Box and A Linkage # LC379160.
If you've got something...
view full answer... - How To Increase The Tension Of A Solera RV Window Awning Roller Tube Spring
- To increase the tension of your Solera RV Window Awning # LC43VR you'll need to remove the screws that hold the end caps onto the arms and twist the endcaps (as pictured below) to increase the tension on the spring. You'll need to have a firm grip on the roller and endcaps as the tension will unravel when the endcap is removed from the arms.
view full answer... - Recommended 44 Series Clearance Trailer Lights
- We do have the lights you are looking for. I have attached a link to our product page for the 44 series lights we carry.
If you are looking for a Red clearance light you can use part # MC44RB. This light measures 4 inches long, 1-1/2 inches wide, and 15/16 inches deep. The mounting holes are spaced 3 inches apart.
For an Amber 44 series clearance light you can use part # MC44AB.
view full answer... - Furrion RV AC Unit that Can be Used in Place of Coleman and Can Heat Strip be Added
- If you have a Coleman setup now the Furrion Chill Replacement RV Air Conditioner for Coleman Setup # FR82PV that you referenced will easily fit and use same wiring regardless of the thermostat you have. The thermostat that you have is setup for a Coleman setup so that means it has the correct wiring for this Furrion setup.
To add a heat strip you'd just need the part # FR35SR.
view full answer... - What is Compressed Length of Quick Drain RV Sewer Hose # D04-0120PB
- The Quick Drain RV Sewer Hose # D04-0120PB referenced in your question measures 10 feet long when it is fully extended. I went out to the warehouse and measured a length of 11-3/8 inches when the hose is in its retracted/compressed position. This is a really nice sewer hose that features a bayonet fitting at one end that will secure to the RV's waste valve.
This hose also comes in a 20 foot long model, with part # D04-0121. The retracted/compressed length of this hose is 23 inches.
I...
view full answer... - Small Storage Reel Option For RV Power Cord Stored Under Storage Compartment
- Depending on how much clearance you have will determine what will work for you. The MORyde Manual Storage Reel # MR77RR is our smallest reel storage we offer, measuring in at 12-3/4" long, 14-15/16" wide, and 13-7/16" tall.
view full answer... - Trailer Hitch Recommendation for a 2011 Itasca Suncruiser 35P to Tow a Jeep Gladiator
- Thanks for reaching out!
I recommend checking out the Draw-Tite Ultra Frame Trailer Hitch Receiver # 41936 for your 2011 Itasca Suncruiser 35P. This is a Class IV hitch with a 2" receiver and a trailer tow rating of 12,000 lbs so it will be more than capable of handling your Jeep Gladiator.
Just make sure you aren't exceeding the tow weight rating of your motorhome and you'll be good to go!
view full answer... - Sway Bar Recommend for 2014 Itasca Cambria and Flat Tow Parts for 2014 Jeep Cherokee Trailhawk
- The Jeep Active Drive II is the correct 4WD transfer case to allow your 2014 Jeep Cherokee Trailhawk to be flat towed as it has a neutral setting that is used for flat towing. There are no speed restrictions I was able to find for your vehicle either. Your 2014 Itasca Cambria Class C would have no problem flat towing this vehicle too.
For sway bars you'd want the part # RM-1139-147 for the rear bar, and part # RM-1139-176 for the front. This will make a huge difference in the handling...
view full answer... - What E-Bike Carrier Do You Recommend For 2013 Itasca Navion iQ Motorhome And A Toyota 4Runner
- I took a look at all of our hitch bike racks rated to carry e-bikes and are motorhome compatible. We only have one rack that weighs under 40 lbs, secures the bikes by the wheels, and is motorhome compatible. It is the rack you mentioned in your question, the Saris SuperClamp HD 2 Bike Platform Rack - 2" Hitches - Wheel Mount, part # SAR44VR. Our next best option is the Kuat Transfer V2 Bike Rack for 2 Bikes - 2" Hitches - Wheel Mount, part # KU84FR.
For starters it is motorhome compatible....
view full answer... - What Does the Return Leveler for Service Error On the Lippert Ground Control Mean
- The Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System part # LC358590 when meet with an error can display a "Return Leveler for Service" message. This is a general code therefore I don't have any specific troubleshooting steps for this. That said, all you need to do to clear the code is press the retract button and enter button simultaneously, holding for about 3 seconds.
If the error code then reappears you will need to take the system in for service as instructed by the...
view full answer... - Troubleshooting Motor On Kwikee Steps Continuing To Run After Steps Are Fully Opened Or Closed
- I reached out to my contact at Lippert and the issue you are describing on the Kwikee Steps on your 2013 Itasca Meridian 34B is a tell tale sign of a bad controller.
The cause is the controller is not detecting the amp draw of the motor when the steps are fully opened/closed and is causing the motor to keep running after the step is fully opened/closed.
The Controller # LC363980 you were looking at is a replacement for Kwikee Revolution Steps. If that is not what you have on your Motorhome...
view full answer... - Recommended Brake Controller For My 2006 Itasca Meridian Motorhome
- If you want to tow a trailer or use a tow dolly with your 2006 Itasca Meridian Motorhome, you will need a brake controller. My brake controller recommendation is the Redarc you inquired about. It will consist of the following items:
Redarc Tow-Pro Elite Trailer Brake Controller - 2 Braking Modes - 1 to 3 Axles - Proportional, part # RED44FR
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers, part # 3027-P
This brake controller comes with a custom wiring harness. It is a proportional...
view full answer...
Go To Results