Hey James,
The bearing numbers used on your trailer aren't listed by the manufacturer unfortunately so we'll need to either remove and check them for their part numbers (if still legible) or measure the spindle and hub using a digital caliper # PTW80157. To get the inner bearing out to check you'll have to remove the grease seal and it will need to be replaced as well.
I've attached a diagram below showing where to measure on the spindle (B= grease seal, C & D= inner/outer bearings)... view full answer...
Hey Johnny,
There unfortunately isn't a guide to tell us the correct awning needed for your trailer so we'll need to get a measurement first to determine the best fit. I'm assuming you're replacing a different awning and not adding one in where there isn't already one. If this is the case then you'll wan to measure from the center of one awning arm to the center of the other awning arm to determine the length.
Once we know the length I can start looking for the right kit to fit your trailer. view full answer...
Hey Bill, based on your brake assembly size the correct replacement adjuster spring would be the part # 046-083-01 which is the size you mentioned needing. view full answer...
Hey James, thanks for all of the info!
It sounds like you're needing a standard hose like the 12' MB Sturgis Propane Hose - 3/8" Male NPT x 3/8" Female Flare Swivel # 100040-144-MBS, but I'm not sure about the splitter you're talking about. If you send in a photo of that splitter I can look and see if that's something that we carry. view full answer...
While you can leave a Solera Family Room for 16' Wide RV Awnings # LC362231 installed all season I would be wary of leaving it set up and the awning out if you are expected to get very strong winds. The strong wind gusts can easily damage the awning and panels due to the large size of it. view full answer...