We do indeed have the replacement slide motor assembly you're looking for, from Lippert. The correct replacement for your Power Gear 522176 is # LC383745. view full answer...
To replace your Magnetek power converter 45 amp series6300A model 6345, I recommend the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers # PD4645V.
The # PD4645V will be a good fit for a replacement and it has an integrated Charge Wizard that monitors your RV's batteries and automatically begins charging when needed. view full answer...
The correct replacement water heater for your current Atwood GC6A 6 gallon water heater is the Atwood RV Water Heater w/ Heat Exchange - Gas and Electric - Automatic Pilot - 8,800 Btu - 6 Gal # AT96163 that you were looking at. This is a gas and electric unit with an automatic pilot light that is 12-1/2" tall x 16" wide x 18" deep.
I've linked a short review video of this part for you to have a look at. view full answer...
To replace the hardware for a 2012 Chevy Traverse hitch you can use the part # RHK on our site and just input your hitch info so we know what parts you need.
If you're wanting the specifics then you need M12-1.75 x 30mm bolts for the Curt # 13424 and etrailer.com # e98863 trailer hitches, but M12-1.75 x 45mm bolts for the Draw-Tite # 75528 trailer hitch. view full answer...
We can definitely set you up with hubs for your 1998 Coleman Pop up. There are going to be several options for a hub since you are dealing with the standard sizing for a 3,500 lb axle. To replace your 8-247 hub I recommend the Dexter hub # 8-247-50UC3-EZ which is a galvanized hub and includes all of your bearings, seals, races and lug nuts. All you will need is some bearing grease. For that I recommend the LubriMatic LMX Industrial Strength Grease # L11390. view full answer...
Yes we do have replacement hardware for the Draw-Tite Max-Frame Trailer Hitch # 76184 which fits your 2019 Chevy Traverse!
All you need to do is go to this product page, enter the model number of your hitch in the box that says "Hitch Item Number" and purchase the kit.
So simply enter "CU29FR" in the "Hitch Item Number" box and then add it to the cart and purchase. We will prepare you a complete set of hardware.
I have added a link to a video review of Replacement Hardware Kit # RHK... view full answer...
From what I can find the 118A light is an amber light that measures 4 inches long by 1-1/2 inches wide. The light we have with these specs is part # MCL44AB but it's only a 2 wire light.
We don't carry Glo-Brite products so I don't have any specific contact numbers to relay for you, but this light should work just fine. view full answer...
Wobble roller # DL21564 is a close match to what you need. It has a 4-1/4 inch diameter and it is 3 inches wide. But it fits on a 7/8 inch diameter shaft and the hub center is 1-1/2 inches wide.
Wobble roller # YR343R-6P could work. It is 4-3/8 inches diameter and 3 inches wide. It fits a 3/4 inch shaft but the hub center is 1-1/2 inches wide. But if the overall width is 3 inches then the hub center width should not matter. view full answer...
Yes, you can get replacement hardware kit # RHK which will replace all the hardware for the hitch. Just enter the hitch number where indicated on the page and our team of hardware ninjas will compile the proper kit. view full answer...