The Thule Elite Van XT 2 Bike Rack item # TH302013 can fit tires up to 2.75" wide. As far as e-bikes go it has a maximum capacity of 42 lbs per bike. view full answer...
The two wires do not have a specific connection required on the Replacement Sensor Switch for Lippert Components Atlas Jack # LC359285. view full answer...
The Replacement Foot Pad for Lippert Hydraulic Ground Control Leveling System # LC324269 is designed to fit the hydraulic jacks on the Ground Control Leveling System. If the jack you are referring to is part of the Lippert Components Hydraulic Ground Control Leveling System then this is the correct replacement. If it is not part of this system you will need to identify the jack with a part number or serial number to find the right replacement. view full answer...
I attached an install video to this page for a Solera slide topper for you to check out. To pick out the correct size you would need to measure the width of your slide out including the flange and then check out the other page I attached where you will then select your awning flange width to see the correct fitting options. view full answer...
I took a look at the instructions, and a separate inlet check valve is not required for the Furrion RV Tankless Water Heater - Gas - Automatic Pilot - 60,000 BTU # FR93FR. view full answer...
Yes, the Replacement Female Quick Disconnect for Demco SBS Air Force One Supplemental Braking System # SM99613 is the correct part. This will replace the damaged female connector on your old SMI Air Force One. view full answer...
The Replacement Slide for Elixir RV Screen Doors - 10-3/4" Wide x 12-1/8" Tall # A77015 can be trimmed down to fit your current track. To keep it centered properly I recommend trimming 1/16" from the top and bottom to get it down to 12" and the 3/4" cant just be trimmed from the flat side to get the width to 10". view full answer...
With your opening being as large as it is you'll definitely want the Furrion RV Tankless Water Heater 18" x 18" Door # FR68SR. All newer units are going to be smaller so you will need to build some framing for the new unit to mount to and I'd also put a thin sheet of plywood to fill in the gap with the 18" x 18" door to cover everything up.
I recommend using some butyl tape # AL28FJ along the mounting flange of the door and some non-sag sealant # 344270341437-1 around it to prevent any... view full answer...
For the 17k Level Best jack replacements we have the part # LC359275 that you referenced. For 10k legs you'd instead want the part # LC359278. view full answer...