LED Trailer Tail Light w/ Reflex Flange - Stop, Turn, Tail - Submersible - Round - Red Lens

Optronics Trailer Lights - OPT29NR

4" Round. Waterproof, trailer tail light with 10 diodes provides stop, turn, and tail functions. Built-in reflex reflector on mounting flange. Durable polycarbonate housing. Recessed mount with built in flange. 3-Wire pigtail.

Features:

• Round tail light provides stop, turn, and tail function
  • Built-in reflector removes the need for a separate reflector
• Sonically sealed, waterproof housing and lens unit is submersible
• LEDs make great replacements for incandescent lights
  • Last 50 times longer
  • More efficient - provide brighter light with less power output
  • No bulbs to replace - no brittle filaments
• Durable polycarbonate housing and lens
• Red lens over white LEDs
• Compatible with 12V DC systems
• Recessed mount to trailer with built-in mounting flange - hardware not included
• 3-Wire design hardwires to trailer
• P2 rated light produces a 90-degree beam pattern
• DOT compliant

Specs:

• Light diameter: 4"
• Diodes: 10
• Power draw at 12V:
  • Stop/turn: 0.413 amps
  • Tail: 0.026 amps
• Lifetime warranty on LEDs

Sonically Sealed, Waterproof Trailer Light

The waterproof construction of this light makes it ideal for use on trailers that may be submerged, like a boat trailer. The housing and lens are sonically sealed together to create a single unit, which means that water will not get into the light and damage the diodes or circuit board.

P2-Rated Lights

A P2-rated light produces a 45-degree angle of light to either side of its centerline for a total of 90 degrees of coverage. This beam pattern can be seen straight on, but it cannot be seen clearly from the side. So this type of light can be used as either a side marker light or a clearance light, but it cannot function as both. If you need both functions, then you must install 2 separate lights on your trailer - one as a front or rear clearance light and one as a side marker light.

Surface-Mount Light

Surface-mount trailer lights install using a flange or bracket with mounting holes. These lights lay flat against the trailer surface and only require a small, often pre-existing hole, for wiring. Mounting hardware is used to secure the light to the trailer.

STL43RBHX LED Tail Light w/ Reflex Reflector Flange - Stop, Turn, Tail - Submersible - 10 Diodes - Round - Red Lens