Replaces the motor from your Meyer or Diamond snow plow. Comparable to Meyer part numbers 15841 and 15727 and Diamond part number 15689. Electric motor has dual posts and sealed construction that resists corrosion.
Features:
Specs:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Speaker 1: Today we're going to take a look at the 4-1/2 inch replacement twin post motor for the Meyer snowplows. Now this motor is designed to fit the Meyer's snowplows. It will replace Meyer's part number 15841 and also the Meyer's part number 15727. Now this motor can be used to replace a single terminal motor that's used on a lot of the older E60 units by using this black jumper ground cable here. Now this will also work on the two terminal motors that are found on the new E60 units and then the jumper wire is not needed when you do that.The diameter on this is 4-1/2 inches and that's measured from this edge to this edge. So if we put a ruler on that measures 4-1/2 inch diameter.
The length on this is going to be, going to measure right to the end here, so you're looking right at 6-3/4 inches long. Now the jumper wire they include, that's 16 inches long, and, again, this is a dual post or dual terminal motor. But that should do it for the review on the 4-1/2 inch replacement twin post motor for the Meyer snowplows.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.