Landscape Trailer Parts and Accessories
Landscape Trailer
Videos
for Landscape Trailer
Help Articles
for Landscape Trailer
Expert Answers
for Landscape Trailer
Yes, because it is a 3-wire light, you can wire the Red Identification Light Bar with White LED Utility Light #OPT88FR to function as rear marker and reverse lights.
view full answer...I went and pulled a Kenda Karrier ST205/75R15 Radial Trailer Tire with 15" Black Mod Wheel #AM32424 from our warehouse to determine the weight capacities and found that on the sidewall it was stamped Load Range D with a 2,150 lb capacity at 65…
view full answer...The best option we have for you is the 3-Leaf Double-Eye Spring part #e84SR with the Single-Axle Trailer Hanger Kit part #APS4. This option will replace the leaf springs and leaf spring hanger brackets which is needed because the new double eye leaf…
view full answer...We do have hitches that fit the 2021 Toyota Rav4 Prime. I recommend the Curt Trailer Hitch Receiver part #C13416 which is a direct bolt-on fit. It is very easy to install and provides the larger 2" receiver tube so you'll have a greater…
view full answer...Trailer or automotive wheels can have a positive or negative offset. The offset refers to the distance between the mounting surface of the wheel that touches the hub and the center line of the wheel, as shown in the diagram I have edited for you. A…
view full answer...The note that says that the Kenda Karrier ST205/75R15 Radial Trailer Tire with 15" Black Mod Wheel #AM32424 shouldn't be used on wet or icy roads is a little misplaced. This is related to the painted steel wheel that it has and its slightly…
view full answer...The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…
view full answer...The Dexter Trailer Idler Axle w/ Hubs - EZ-Lube - 5 on 4-1/2 Bolt Pattern - 60" Long - 2,200 lbs #20545I-EZ-60-15 is a great starting point to upgrade your trailer. This will give you a standard size axle with good bearings, hubs, and EZ-lube…
view full answer...The Timbren Axle-Less Trailer Suspension System - Straight Spindle Only - 3,500 lbs #ASR3500S05 has a deflection of 1-3/4 inches. I've attached a photo to assist. We recommend 4 inches above the tire in most cases for fender mounting to account…
view full answer...To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…
view full answer...If you were happy with the ground clearance that the trailer had with the old setup then I would recommend you stick with the way you had it with the axle below the springs. If you moved the axle above the spring you would lose ground clearance and…
view full answer...