Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Ellen: Hey, everybody. I'm Ellen here at etrailer.com and we're taking a quick look at the pro screwdriver set. This is going to give you a lot of different tools for any kind of job that you might have where you need to get in there and tighten up any kind of bolts or anything else like that.So most of this is going to be different kind of a flathead or Phillips screwdrivers of various sizes. We do have a couple of other kind of odder sizes. We'll have a square R2, which is four inches long, and then two torques bit. One is going to be a T15 and then a T20.
Both of those are also four inches.And then you also get a scratch awl, so if you need a mark out any kind of mounting hole or anything like that, make a scratch in the metal to find your spot to drill, that really helps to do that.Also do have an offset screwdriver. So we'll have a Phillips and a flathead on either side of that. And again, just kind of helps to get into an odder space or give you a little quicker range of motion so that you can kind of tighten that down a little faster.As far as the sizes, let's take a little closer look. We'll have our short Phillips and flathead here. These are both going to measure about two inches long...
Or an inch and a half long, excuse me. And then we'll have these two, which are going to be about two and a half, but they're smaller tips. And they do have a little clip. So if you want to keep those in a pocket, keep them readily available, allows you to do that. Have our three-inch long.
It's going to be a 13/16th edge to it.And then our 13 inch. Or excuse me, three-inch Phillips, four inch, and also a six inch. They are all labeled on the handle, so if you have a job where it requires a specific set, you can always reference those to make sure that you have the right one.The handles are pretty comfortable, pretty typical for most of these sets. They are a little oversized to help to give you a good grip and they do also have a magnetic tip. That's true of all of these guys, including the offset.
So it makes it easy to keep your hardware where it needs to go, rather than it falling down and getting lost. And I tested all of these. They do all hold on to any screws you that might happen to be using.That's pretty much all there is to it for our look at this pro screwdriver set. Just wanted to kind of go over what comes in the kit, show you a little bit about each one. And that's, I hope, a helpful video to make sure that this is the right set for you. We do have a lot of other tool sets here at etrailer.com as well as a lot of other accessories, so check them out. Thanks for watching.
Average Customer Rating: 5.0 out of 5 stars (1 Customer Reviews)
Have a 5th wheel need some special type of screw drivers fit the bill
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.