To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
Ease installation of your electric trailer brake controller by using this custom wiring adapter. Simply connect the 4 wires of the harness to your brake controller and then plug the other end into the built-in port behind your vehicle's dash.
Features:
To install your electric brake controller, you need to connect the wiring of the controller to your vehicle. Certain auto manufacturers offer pre-wired options, typically known as tow packages, wherein wiring is run for you from the dash to the trailer connector on the back of your vehicle. When this is done, a port is installed at your dash so that you can easily plug in a brake controller.
This adapter plugs into the port on your vehicle's built-in brake control wiring harness, which is located behind the dashboard. To reach the connector, you will have to remove the ashtray (A), the lower convenience panel (B), both lower switch panels (C), and the upper dash assembly (D). Use a trim panel puller to carefully pry these pieces out. The connector can be found behind this portion of your dashboard.
To hook this adapter up to your trailer brake controller, just connect the 4 wires of the harness - ground, power, brake switch, and brake power - to the corresponding wires on the brake controller. If your brake controller came with a plug built into its wiring harness, you will have to cut off the plug and connect to the wires themselves.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're looking at part number TM75270 from TrailerMate. This is a custom wiring adapter for your trailer brake controller. It's made specifically for the Ford Econoline Van and Ford F-250 through F-550 Super Duty Truck. You should use our fit guide to determine the model years that this works for to see if it works for your vehicle. This is a very easy way to install your brake controller. You simply plug the gray terminal here into the factory port that's underneath your dash and then you connect the copper wires here, the pigtail, into the back of your brake controller using the included butt connectors.
The copper is stranded type copper and that's top quality. Once you get it installed, if there's any slack in the wire you can use the included cable ties to take that up. This is compatible with both time delayed and proportional brake controllers made by TrailerMate, Draw-Tite, and Tekonsha. That's it for part number TM75270, the TrailerMate Custom Wiring Adapter.
Do you have a question about this Accessories and Part?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.