Replacement 9" Diameter Bumper Wheel for Taylor Made Dock Wheel Bumper

Video Transcript for Review of Taylor Made Dock Accessories - Replacement Bumper Wheel - 36991078

Hello everybody. This is Jeff at etrailer.com. Today, we're gonna take a look at this replacement nine inch diameter bumper wheel for your Taylor Made dock wheel bumper assembly. Now, this part will replace the inflatable wheel from the Taylor Made dock wheel bumper assembly. For the part number, works with the assembly part number 3691078 or 3691079. Both of those assemblies we do sell separately on our website.

This wheel bumper will roll to guide your boat into the marina slip while keeping it from hitting the dock. You can see on the side, has a nice, non-marring ribbed surface, so it won't drag along your boat's hull. Does, on the very top here, have the molded-in needle inflation valve seat, which is harder to tear off than the glued valve seat. Just put your inflation needle in there and put the air on the ins, or pump the air onto the inside. You can see it is a nice, bright white color.

It is made in the USA. And it does include the bolt and the washers for installation. Few specs, again, the diameter on this is gonna be right at nine inches. Overall height, from the bottom to the very top, 5 3/4 inches. And the axle housing diameter right down here that goes over the axle is 3/4 of an inch.

But that should do it for the review on the replacement nine inch diameter bumper wheel for the Taylor Made dock wheel bumper assembly..