SeaSucker MTB Plugs and Skewer for 12 mm x 100 mm Front Hub

Video Transcript for Review of SeaSucker Roof Bike Rack Parts - MTB Plugs and Skewer - SEA34FR

Hey everybody, I'm Ellen here at etrailer.com. And we are taking a quick look at this replacement Skewer with the hubs. This allows you to adapt your front hub, on your bike, to work with the SeaSucker Flight Deck and Wheel Holder. So this works with a 12 millimeter by 100 millimeter Skewer and allows it to plug into, the hubs are going to plug in to there, fill the gap. And allow you to just easily drop your bike in and come back out. So, it's just going to be this piece here.

We can take a little closer look at it. So it's just going to be a cam that goes over to tighten into that hub. And it also comes with the Skewer. So, again, it also works with bikes that have that 12 millimeter by 100 millimeter front hub. It's made out of aluminum.

And the ends have black powder coat finish. So, that gives it kind of a nice contrasting look there. It is covered by a Limited Lifetime Warranty. And again this does work for the SeaSucker Flight Deck and the add on Front Wheel Holder. Got the 2 springs there to create tension on it.

And that's pretty much all there is to it for quick look at the SeaSucker MTB Plugs and Skewer. Hope this has been helpful in deciding if this is the right part for you. We do have a lot of other SeaSucker accessories here at etrailer.com. And all kinds of stuff to haul your bikes down the roads. So, be sure to check it out.

And thanks for watching.