Oval Snap-On Bezel for Optronics Fusion LED Tail Light - Primed Finish

Video Transcript for Review of Optronics Trailer Lights - Snap On Oval Bezel - OPT22ER

Hello, everybody. This is Jeff at etrailer.com. Today I'm gonna take a look at this oval snap-on bezel for the Optronics Fusion LED Tail Lights. Now, this plastic bezel has the oval design, so it'll let you mount the Optronics STL211 Series Fusion LED Tail Lights to your trailer. And we mentioned, it as a snap-on design for easy mounting. And just to demonstrate that, I happen to pull one of those STL211 Series lights.

You can see it right here. And basically, if you push it in through the front, and if you push it in far enough, you can see that this will, just like that, clip in place. And just like that, you're all ready to go. Has the clips, one on each end, and one on each top and bottom, and it holds your tail light in place. Now, the prime finish on the bezel will let you finish your Optronics Fusion LED tail light to match your trailers color, if you prefer.

It is a durable, plastic construction. And then I'm just gonna go ahead and pop the light back out. And just like that, you can see, allow you to pop the light right out. Few dimensions on this. Wanna measure the overall dimension from one end to the other.

So, put a rule on that. You can see that's seven and seven eights inches. Width on it, bottom to the top, three and five eights inches. And then, the thickness of this is right at about a half an inch thick. Now, the inside opening where the light would go, it's gonna be right at six and a half inches by two and a quarter inches.

But that should do it for the review on this oval snap-on bezel for the Optronics Fusion LED Tail Lights.