Wind Fairing for Front Runner Low Profile Slimline II Platform Racks - 52-7/8" - 56-1/8"

Video Transcript for Review of Front Runner Wind Fairing Low Profile Slimline II Platform Rack - FR35ZV

Hi, everybody. Andy here with etrailer.com. Let's take a look at this wind fairing for your Front Runner Low Profile Slimline II platform rack. Now, this aerodynamic fairing is going to deflect air over your 52-7/8 inch to 56-1/8 inch wide Slimline II low profile platform rack. And this is going to help reduce wind noise and drag. And the sleek design is going to enhance the look of your rack.

Now, taking a look overhead, I would like to give you just some overall measurements of the fairing so you have a good idea of the size. So beginning with the overall width, we are sitting right at about 48 or 49 rather and 11/16 inches wide. And then measuring the center height, we're sitting right at about five inches tall. And the fairing weighs a little over three pounds. And if you have a standard and tall profile rack, this fairing will not be compatible with that.

Instead, you'll wanna use the Front Runner wind fairings for standard or tall racks identified by our item numbers that you see there on your screen. You can just take those item numbers and put them in the search field of our website and that will take you to that compatible fairing for your standard or tall profile rack. And on the bottom of this fairing, we do have a rubber seal that's going to eliminate the gaps between the fairing and your roof. And you probably can't see it here on our table, but we do have a clear protective strip that's going to prevent scuffs to your finish. And you're just going to peel that strip off of this backing and then that's just going to stick to the roof of your vehicle and prevent that scuffing and then scratching.

So that strip is included. And then these adjustable brackets are included with the hardware and this is going to let you angle this fairing for the best performance. And on the fairing itself, right here in the center, we do have a perforated punch out section to accommodate for center front antennas and shark fins. And I do wanna point out that this may interfere with sunroof operation on some vehicles. And this is going to be an easy installation on the front bottom channel of your Front Runner Slimline II low profile platform rack, again with the included brackets and hardware.

And the black powder coated aluminum is going to be very durable, very long lasting and then you're not gonna have to worry about rust or corrosion. Well, that's gonna wrap up our look today. I do hope that it was helpful for you. Again, my name is Andy. Thank you for joining me.