Trailer Wiring Harness Installation - 2001 Ford Windstar- Video
Today on this 2001 Ford Windstar, were going to install part number 118366. This is the T-One Vehicle Wiring Harness with the 4-Pole Flat Trailer Connector. Now our connection points for wire harness are behind the taillights, so we need to open the tailgate and remove the taillights. Use a Phillips screwdriver to remove these two screws. Well go ahead and remove our light. It looks like somebodys been in here once already because it came off pretty easy. more
12/12/2014 12:55:06 PM
Trailer Wiring Harness Installation - 2002 Ford Windstar- Video
Today on this 2002 Ford Windstar we are going to be installing wiring harness part number 118366. We are here at the rear cargo area of the Windstar, we want to locate the ports that we need to plug our wiring harness into. These ports are located directly behind the tail light assembly on both the driver and passenger sides. The first thing we are going to do is remove the tail light assemblies. To do that we have two Phillips head screws at the top of the tail light that we are going to remove. With those two sides removed we also need to release this inside clips that are holding the tail light assembly on. There is one on the outboard side and one on the inboard side at the bottom. And then starting on the passenger side, we are going to start plugging the harness in line. On the passenger side we are actually going to be using two of the plug ins here. Using the top one and the middle one. If you look at the harness you can see on the short side of it you actually have two sets of connectors that are color coordinated to match the connectors on the vehicle. 1:09 more
6/18/2010 11:34:44 AM
Trailer Wiring Harness Installation - 2000 Ford Windstar- Video
Today we are going to install part number 118366 from Tow Ready on a 2000 Ford Windstar. To get started, what we want to do is go ahead and lift up the tailgate and start taking off the passengers side tail light. Okay, the connection points are going to be on the gray connector here and the black connector. The green one is for the reverse light lead, and we will have nothing to do with that. We have got a lot of wires to hook up, so we are going to do it one step at a time. First off, we have got our 4-pole here, which will get run through the grommet to the inside and be stored by the jack storage compartment when we are not using it. But for now we are just going to go ahead and just tuck it down in the cavity here, just to get it out of our way. Next, this is the yellow wire this is what goes over to the drivers side of the vehicle. more
8/2/2009 10:57:46 PM
Filter Videos
Filter Videos
