Curt Hitch Ball with 1 inch Rise Review Video

Due to the thinner gauge wiring of the #118290 for the 12 volt accessory circuit you'd be limited to the 20 amp charger for your battery.

The correct wiring harness needed will depend on the type of trailer you're wanting to pull. If you're pulling something basic like a small utility trailer and only need a 4 pole trailer connector, the #118790 would be what you need. However,…

In order to get a ball mount that has effectively 0 inches of rise or drop you would need to get a Trailer Hitch Ball Mount, part #D-4, like the one you referenced that has a 2 inch drop, and then use a 2 Inch High Rise Ball, part #C40034. I attached…

If you have access to a large vice I would wrap the 2-5/16" Hitch Ball #C40086 in a thicker shop rag and then use the vice to really crank down tight on it to keep it from spinning while torqueing the nut.

A chrome finish ball #C40036 is going to look good but it will not be corrosion resistant. A ball with a machine finish like #C40087 , is going to have about the same corrosion resistance. In terms of performance they will wear at about the same rate…

From the base of the ball to the top on hi-rise ball #C40087 is approximately 5 inches. I have linked a video review of this ball for you.

I have a couple options for you as we do not have a double ended 7-Way Molded Trailer Wire Connector in a 10' length. First you can take a 7-Way Molded Connector w/ 10' Cable #50-67-005 and add a 7-Way RV Style Trailer Connector #A7WCB. Or…