Gen-Y Hitch Pintle Hitch - Pintle Mounting Plate - 325-GH-1201 Review Video

You cannot use a weight distribution system with a pintle hitch. You would need to remove the pintle hitch you have now in order to use a weight distribution system. Once you do this, I recommend using the Equal-i-zer Weight Distribution System which…

The B and W Hitch #BWHDRH25122 is a confirmed fit for a Ford F-450 Cab and Chassis model that has a 34 inch frame and has a 16k capacity with the smallest amount of drop of the hitches available. I attached pictures that show how much drop it would…

Yes, check out the picture I attached that has the vertical distances from where the hitch mounts to the frame of the vehicle down to the hitch tube. Since you need at least 6 inches this would clear that by 1-3/8 inches.

I was able to get a dimension sheet from my contact at Curt for the Curt Hitch part #C15800 that you referenced. See attached pic. I also attached a set of the installation instructions for this hitch.

Yes, you could remove the ball mounts of the #C45900 and then install a pintle hook in it's place like the part #C45920. Of you could go with just the channel part #C45910 and the pintle #C45920 if that's all you are really after.

Curt does offer just the replacement shank for the Adjustable Ball Mount part #C45926 with the part #C45910.

In order to choose the correct weight distribution system, you will need to find the total tongue weight (TTW) of your towing setup by adding the tongue weight (TW) of both your loaded ready to tow trailer and any cargo stored behind the rear axle of…

You'd need a high rated weight distribution system for a trailer that weighs 14k. We have the Blue Ox SwayPro kit part #BWX2000 which has a tongue weight range of 1,500 - 2,000 lbs which would be about right for your 14k rated trailer. For a…

The difference between the Bulldog Cast Head Coupler, #BD4420000317, and the similar #BD4425000317, is exactly what you have said. The latter coupler has a 25,000 pound capacity rating while the first one is rated at only 20,000 pounds. The higher…

First, you will need a trailer hitch that is capable of the weight of your trailer with the dozer on it. The only hitch that will fit your 2002 Ford F-350 and has the capacity is TorkLift hitch #TLF1002-30. In order to get it to its maximum capacity…

We have the Curt hitch extender that fits 2-1/2 inch hitches part #C45048 and can be trimmed down from 34 inches to 24 inches. At 34 inches it has a capacity of 6,000 lb trailer weight and at 24 inches 8,000 lbs trailer weight.

I have a great hitch solution for you. However, the Draw-Tite - 2-1/2" DT32MR does not fit your 2020 Dodge Ram 5500. With that being said, we do have a great 2-1/2" hitch solution for you. That is the Curt Trailer Hitch Receiver - Custom…