Is It Possible to Improve Trailer Breakaway Battery Charging, Towed by 2012 Ford F-150
Question:
Between stops my batteries rarely reach full charge. Any way to increase rate of charge?
asked by: Tim C
Expert Reply:
I would make sure that the 12 volt accessory circuit of your trailer's wiring is using 10 gauge wire. Basically the thicker gauge the wire the more current it can carry to your battery charger.
Also, I would make sure the ground of the battery is using a thick gauge wire and is attached to a clean metal surface.
If you need wire we sell 10 gauge wire # 10-1-1 by the foot.
It could also be that you have a weak breakaway battery that just doesn't want to hold a charge.
I attached an FAQ article on breakaway systems for you to check out as well.
Products Referenced in This Question
Product Page this Question was Asked From
Trailer Breakaway Kit Battery Charger
- Accessories and Parts
- Trailer Breakaway Kit
- Battery Charger
- Hopkins
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Charging a Trailer Breakaway System Battery Using the 12 Volt Circuit on a 7-Way Connector
- Q&A: Will the Hopkins Trailer Breakaway Battery Charger Work for an Auxiliary Battery on a Trailer
- Q&A: How to Charge a Trailer Battery Through a 7-Way Connector
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Q&A: Replacement Brake Magnet for 2013 Keystone Hideout with 3,500 lb Axles
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Flat Towing Package for 2019 Jeep Cherokee
- Q&A: Blue Ox Weight Distribution System with Higher Tongue Weight Rating that 1,700 lb Reese
- Q&A: How to Prevent Trailer Breakaway System Battery from Overcharging and Back Feeding Into Tow Vehicle
- Q&A: Comparing Tire Sizes ST185/80D13 and ST175/80R13 and Bias Ply/Radial Tire Construction
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Testing Breakaway Systems