Recommended LED Light Bar For The Back of An Enclosed Trailer
Question:
Hi, I have an enclosed trailer that I want to add an LED bar on the top rear of it. How do I wire the LED light bar into the rest of my lights already on the trailer?
asked by: Cody
Expert Reply:
The LED light bar strip I recommend is # MCL93RB. Each strip has 3 LED lights on the base. They are sealed, waterproof and corrosion resistant. Contains both lead wire and ground wire for mounting to all surfaces.
The LED light bar strip # MCL93RB is a two wire system meaning you will have one wire with a ring terminal for your ground, and a 50-inch power lead wire. You will connect the white wire to your ground and the brown power wire lead to your power supply.
Product Page this Question was Asked From
LED Identification Light Bar for Trailers over 80" Wide - Submersible - 9 Diodes - Red Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- ID Bar
- Surface Mount
- Submersible Lights
- LED Light
- 15-15/16L x 1-1/2W Inch
- Red
- Optronics
more information >
Continue Researching
- Article: How to Charge a Dump Trailer Battery
- Q&A: Recommended Lithium Battery Compatible Power Converter For Parallax 7355
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: How Much Slack Is Needed In Trailer Wire Connection To The Tow Vehicle?
- Q&A: Replacement RV AC Unit for Dometic B57915.711J0
- Q&A: Recommended Replacement Grease Seal for 2014 Shorelander Boat Trailer
- Q&A: Replacement Parts for ELX-45 Power Converter
- Q&A: Replacement Trailer Hub/Drum for Part Number 2420801
- Q&A: Replacement Leaf Spring Bolts and Bushings for Dexter 10K Axle On Big Tex Trailer
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Hitch Receiver Sizes
- Article: Surviving the Night in a Teardrop Camper...During a Winter Storm
- Article: Trailer Wiring Diagrams
- Article: Roadmaster Vehicle Specific Base Plates