Where to Tap Into on a 2004 Chevy Tahoe to Add Extra Brake, Tail, and Turn Signal Lights
Question:
no one ever covers this, where do I tap in to? I am adding stop turn and tail lights to both ends , Not tail in front, yellow in front, red back Thank You p.s. using post two sided LED lights for the bumpers ends
asked by: Norm S
Helpful Expert Reply:
You will need to identify the correct wires for each function on the 2004 Chevy Tahoe by either tracing the wires or by using a circuit tester such as # PTW2993. So, for example, for an additional turn signal at the front you would find an existing turn signal wire at the front and splice into it. The same goes for the other functions.
For the back you would do the same thing; identify the wires and tap in accordingly.
Product Page this Question was Asked From
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: How to Troubleshoot Your RV Air Conditioner
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Testing Trailer Brake Magnets for Proper Function
- Q&A: How to Test Brake Controller without Trailer Connected
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Q&A: How to Make an Adapter to Go from Semi Truck 7-Way Round to RV Style 7-Way Blade on Trailer
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Q&A: Troubleshooting No Running Lights on Trailer but Turn Signals and Brake Lights Work
- Q&A: Will The Curt Dinghy Wire Harness # C96JR Interfere With Activation Of A Blue Ox Patriot
- Q&A: Checking Trailer Lights Without Hooking Up to Vehicle?