Prodigy Trailer Brake Controller Shows NC with or Without Trailer Connected, Stops with Brake Pedal
Question:
My controller shows NC when the trailer is not hooked up or the trailer is hooked up. When you push on the break peddle the NC goes away
asked by: Kevin A
Expert Reply:
The Prodigy brake controller and other controllers will send back a little bit of voltage to check for a trailer. If there is a loose connection or corrosion built up in the trailer or vehicle side trailer connectors then that could affect the controller's ability to sense the trailer.
There is some testing you can do to determine where the problem is. In the truck cab you will need to sever the blue wire several inches from the back of the controller. Then use a circuit tester such as # PTW2993 to test the end of the blue wire coming out of the controller. It should only have power when you apply the manual override (or brake pedal on some controllers). If it shows power at idle, then there is something wrong with the controller and it will need to be replaced.
If it tests fine then reconnect the blue wire. Then move on to the truck side trailer connector. Many times, dirt or corrosion can cause a short in a trailer connector. Make sure the truck and the trailer side connectors are clean and free of corrosion inside and out.
You can test the brake output pin and it should only show power with the manual override. If it shows power any other time then there is a short somewhere between the connector and the brake controller you will need to track down.
If the truck side checks out fine then it could be the wiring to the brake magnets or the magnets themselves. Inspect the power wires to the magnets and look for pinched, frayed, or damaged wires and fix as needed. Make sure the ground wires are attached to clean and corrosion free bare metal surfaces.
You can visually inspect the magnets and if you can see the copper windings coming through the magnets will need to be replaced. To further test the magnets you can follow the help article I have linked. I have also included some help articles on testing and troubleshooting brake controllers for you.
Product Page this Question was Asked From
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Q&A: How to Make an Adapter to Go from Semi Truck 7-Way Round to RV Style 7-Way Blade on Trailer
- Article: Troubleshooting Brake Controller Installations
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Q&A: Will The Curt Dinghy Wire Harness # C96JR Interfere With Activation Of A Blue Ox Patriot
- Q&A: Troubleshooting No Running Lights on Trailer but Turn Signals and Brake Lights Work
- Q&A: Checking Trailer Lights Without Hooking Up to Vehicle?
- Q&A: Trailer Lights Left Side Turn Signal and Brake Lights Not Working