Installing Curt Custom Fit Vehicle Wiring for the 2004 Honda Odyssey # C55336
Question:
The videos all seem to show the installation of the Pre-wired 7- and 4-way trailer connector with a rectangular tube hitch. The Curt C13068 is a round tube hitch. Should I be using DrawTite #18159 Connector Box for my Honda Odyssey application? Do you have any videos showing this sideways installation of the Pre-wired 7- and 4-way trailer connector in Curt C13068?
asked by: Gary
Helpful Expert Reply:
The Curt custom-fit wiring harness for the 2004 Honda Odyssey is their part # C55336 and this plugs into wiring on the vehicle to provide a 4-pole flat trailer connector. If you will be installing a brake controller kit # ETBC7 the included 7-way will plug into the 4-pole from the harness and you will make the additional wiring connections required for the other 3 functions supported by a 7-way connector (12V power, brake signal and reverse light).
The # ETBC7 includes a mounting bracket for the 7-way that allows it to be mounted to the underside of the bumper. If you prefer to mount the 7-way to the round tube on Curt hitch # C13068 then in that case you could use the Draw-Tite 6 and 7-Way Trailer Connector Mounting Box for Round or Square Tube Hitches # 18159.
I have linked install instructions and videos for the Curt hitch and for the # ETBC7 kit.
Products Referenced in This Question
6 and 7-Way Trailer Connector Mounting Box for Round or Square Tube Hitches
- Accessories and Parts
- Trailer Wiring
- Mounting Hardware
- Brackets
- 6 Round
- 7 Round
- Draw-Tite
more information >
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 5000 lbs WD GTW
- 2 Inch Hitch
- 500 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Custom Fit
- 4 Flat
- CURT
more information >