Replacing Bulb on Peterson Square Trailer Tail Light # 432400
Question:
How do you remove and replace the trailer lights
asked by: Don
Expert Reply:
To change the bulbs in Peterson trailer tail light # 432400 you will first remove the main lens which is held on by 4 screws.
The main bulb can be removed by pushing down and rotating the bulb counterclockwise. There is a diagram on the inside of the case that explains this and it says turn it 30 degrees then pull up. I had to turn it several more times when I played with the light so it probably varies slightly.
To install a new 1157 bulb # 30-90-157 you will line up the lower nub on the light base with the upper slot and push the bulb in. It will snap into place. This is also shown on the inside of the light in a little diagram.
The other bulb just pulls right out.
Product Page this Question was Asked From
Peterson Combination Trailer Tail Light - 7 Function - Incandescent - Square - Driver Side
- Trailer Lights
- Tail Lights
- License Plate
- Rear Reflector
- Side Marker
- Side Reflector
- Stop/Turn/Tail
- Square
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 4-3/4L x 4-1/2W Inch
- Red
- Peterson
more information >
Continue Researching
- Video: Review of Peterson Peterson - Trailer Lights - 429005
- Shop: Peterson Combination Trailer Tail Light - 7 Function - Incandescent - Square - Driver Side
- Shop: Peterson Trailer Tail Light - Stop, Turn, Tail - Incandescent - Pedestal Mount - Round - Red Lens
- Shop: Replacement Light Bulb # 1157
- Search Results: towing mirrors
- Video: K-Source Custom Extendable Towing Mirror Review
- Shop: K-Source Custom Extendable Towing Mirror - Electric/Heat - Textured Black - Driver Side
- Shop: Towing Mirrors
- Q&A: Bulb Replacement Part Numbers for 432400 Peterson Square Trailer Tail Light
- Shop: Peterson Combination Trailer Tail Light - 6 Function - Incandescent - Square - Passenger Side
- Search Results: yates 343r roller
- Video: Yates Rubber Boat Trailer Parts - Roller and Bunk Parts - YR530R-7P Review
- Shop: CE Smith Wobble Roller Washer for 1-1/8" Shaft - Zinc-Plated Steel - Qty 1
- Shop: Yates Ribbed Wobble Roller - Heavy-Duty Rubber - 5" Diameter - 1" Shaft
- Q&A: How Do You Remove The Peterson Replacement Lens, # 440-15R, On The Taillight To Replace A Bulb
- Video: Peterson Round Flush Mount Trailer Tail Light Installation
- Q&A: Replacement Leaf Springs for Tandem Axle Trailer
- Q&A: Replaced Leaf Springs On Tandem Axle Boat Trailer And The Rear Springs Are Tilting Rear Axle Forward
- Q&A: How to Remove and Install 1157 Bulb From Trailer Lights
- Q&A: Is a Specific 1157 Light Bulb Used for Boat Trailer Tail Lights
- Q&A: Troubleshooting 1157 Replacement Light Bulb That Will Not Illuminate
- Video: Peterson Trailer Lights - Tail Lights - 432200 Review
- Search Results: trailer door holder
- Search Results: 1157 replacement bulbs
- Search Results: rubber socket door holder
- Video: Review of Peterson - Trailer Lights - 844-252
- Search Results: slide out saddle racks
- Video: Draw-Tite Max-Frame Trailer Hitch Installation - 2020 Subaru Outback Wagon
- Shop: Trailer Hitch