Dimensions for Mounting Holes on Draw-Tite Max-Frame Trailer Hitch Receiver # 75186

Question:

Hello, replacing existing class III draw tite on 02 frontier crew cab short bed. What is the bolt pattern on this item?.. I would rather not weld/redrill the frame. Thanks

asked by: Rick

Expert Reply:

I went to our warehouse and took these measurements off the Draw-Tite Max-Frame Trailer Hitch Receiver # 75186. All the measurements are from the center of hole to center of the next hole. For the width it is 39-3/4" on center. Starting from the rearmost holes when it would be on the vehicle they are 2" on center, 5" on center and 3" on center.

I have also linked the installation instructions for this receiver near the bottom of the page since not all of the mounting holes are used for the installation.

expert reply by: Bud M