Light Kit For Air Force One Supplemental Braking System

Question

Question:

I need the light kit showing my air force 1 braking system is working while pulling my tow from my motorhome. Do you install the inside my coach or inside the towed vehicle? Id like to know what I need, how its installed, cost, and when I can receive. Than you

asked by: Mark H

0

Expert Reply:

So this will depend on if you want an in cab monitor like the Coachlink # SM99945 or a light in your flat towed vehicle like what comes with the basic Demco Air Force One # SM99243. I have linked the instructions for the Air Force One near the bottom of the page and you will want to go to page 26 where you can see the installation start for the LED Monitor Light # SM99612. Then you will need to check and ensure you have the Reed Switch # DM65MV which you can see on page 27 of the instructions. As of today 4/15/2024 all these different parts are in stock so you can add them to your shopping cart depending on which parts you need and prefer to go with which will give you cost and shipping information.

expert reply by: Bud M

0

Mark H.

4/16/2024

I’d like to order part #SM99612. I’d need it within 5 days at zip code 33953 in SW Florida. Can you make this happen?

Reply

Bud M.

4/16/2024

@MarkH Once you add the LED Monitor Light # SM99612 to the cart and enter your shipping information you will be able to select the shipping option you want to get it to your door in time. I cannot process orders for you, if you need additional help you can call the customer service phone number located at the top left of this page.

Reply

Mark

4/16/2024

@BudM Since I don’t have a light now and I never did which part do you recommend? I noticed 2 different parts look the same but 1 is like $31 and another is $41. So which one? Thanks

Reply

Bud M.

4/16/2024

@Mark I do see the LED Monitor Light # SM99612 but I'm not sure what other part you are referring too. If you saw the Reed Switch # DM65MV which I linked above too this is a different part and both are required if you do not already have either of them.

Reply

Answer 1

Hi Timothy; for your 2024 Chevy Silverado 1500 diesel we have the Draw-Tite Front Mount Trailer Hitch Receiver #DT44HR. This is the only front hitch without the diesel restriction.

view full answer...

Answer 2

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 3

Hey Dustin, thanks for reaching out! I will recommend SumoSprings over Timbrens all day everyday because they are much more forgiving when the vehicle is unloaded. We've actually joked around here about how the Timbren kits will either give you…

view full answer...

Answer 4

A 2023 Chevy Silverado 1500 will need to have 4WD and a two-speed transfer case, which will need to be placed in neutral, in order to safely flat tow. Your owner's manual will have a list of instructions to follow to switch your transfer case…

view full answer...

Answer 5

On oil bath hubs the seals are different than standard grease seals. The correct replacement for what you have is #91030. Unitized oil seals like this have a part that stays fixed and a part that rotates with the hub for optimum leak protection. I…

view full answer...

Answer 6

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 7

I checked with Curt and they do show the Curt Trailer Hitch Receiver part #C13233 as a fit for a 2022 Volvo XC90 All Models which includes the Recharge.

view full answer...

Answer 8

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...

Answer 9

There is a suggested and common method for 6 function trailer wiring. You will have the following functions: Right Turn, Left Turn, Ground, Tail/marker, Brake, Battery. I have included a help article on trailer wiring that includes a diagram and…

view full answer...

Answer 10

For your 2024 Chevy Silverado 1500 I recommend the Redarc Tow Pro Elite #RED63RR. You can use it along with the Plug in Adapter #3064-P for a plug and play install, since you already have the factory tow package. The Redarc controller is going to be…

view full answer...

Answer 11

That spindle looks pretty well destroyed so best option is going to be to replace the axle. You are going to need to measure your current axles in a few places to get the correct one as we don't have access to what your numbers reference. You…

view full answer...

Answer 12

Mixing and matching the brackets and air springs isn't really recommended but you might be able to get a combination to work. If I were you I would just put the complete #AL88288 kit on since that would fit properly and there wouldn't be any…

view full answer...

Light Kit For Air Force One Supplemental Braking System

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching