Mounting Ultimate Trailer Jack to Crossmember
Question:
Ultimate Trailer Jack - A-Frame - Topwind - 27-1/2 Lift - 2,000 lbs Item 322-RDJ-2K Is there a way to mount this to a cross member of the trailer yoke?
asked by: Donald S
Expert Reply:
The Ultimate Trailer Jack # 322-RDJ-2K is designed to fit your standard A-frame mount. I suppose you could construct some kind of bracket that would allow you to use the mounting bracket on the jack with the crossmember. The bracket hole spacing (center on center) is 3" x 3-1/4". It would probably be best to try and add in an extra crossmember with the mounting holes rather than modify the existing one to accommodate the jack. Welding works for just about anything but with the way this functions I don't think that would be a good idea.
Product Page this Question was Asked From
Ultimate Trailer Jack - A-Frame - Topwind - 27-1/2" Lift - 2,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Topwind Jack
- 28 Inch Lift
- Bolt-On
- Weld-On
- With Rectangle Foot
- Ultimate Jack
more information >
Continue Researching
- Q&A: How to Wire a 6 Pole Round Trailer End Plug
- Q&A: Dust Cover/Cap Solution for Harbor Freight Trailer
- Q&A: Best Replacement for Coach Steps 725-0041
- Article: Trailer Wiring Diagrams
- Article: 2023 Best Gifts for Haulers & Towers
- Q&A: Trouble Finding the Brake Controller Wiring Port on a 2019 Chevy Blazer
- Q&A: Where is the Factory Trailer Brake Controller Port On a 2022 Chevrolet Tahoe
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Determining Replacement Hub And Bearings For Dexter P-12 SLR Trailer Axle
- Article: How to Charge RV Batteries
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Curt Hitch that Fits 2023 Toyota Crown Hybrid
- Article: What Exactly is Tongue Weight?
- Article: How to Measure for Trailer Hitch Drop