Receiver Tube Depth Of The Draw-Tite Max-Frame Trailer Hitch Receiver # 76025
Question:
From Velocirax website: inch the depth of the hitch has to be at least 3 3/8 inches 86mm past the hitch pin hole. Can someone confirm the depth of the hitch receiver has at least 3 3/8 depth _past_ the pin?
asked by: Kyle S
0
Expert Reply:
Hey Kyle,
I went out to the warehouse and measured the Draw-Tite Max-Frame Trailer Hitch Receiver # 76025 and found that there was a 5" distance from the center of the hitch pin hole to the end of the receiver tube, giving you more than enough clearance for your Velocirax bike rack.
expert reply by:
Kevin C
0
![Kevin C](https://images.etrailer.com/static/images/catg/people/2455_tn.jpg)
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 525 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Q&A: Comparison Between Draw-Tite 76025 and EcoHitch 306-X7253 for 2015 Honda Odyssey
- Q&A: Recommended Mounting a 7-Way Trailer Connector on Hitch with Hidden Crossbar
- Q&A: Removing Driver Side Under Body Trim Panel for Hitch Install on a 2014 Honda Odyssey
- Article: Anti-Rattle Devices
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Engine Oil Coolers
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Wiring Diagrams
- Article: Frequently Asked Questions About Transmission Coolers
- Q&A: How to Change Battery Mode on Progressive Dynamics 9300 Series RV Converter Charger
- Q&A: Transmission Cooler Recommendations for 2014 Honda Odyssey
- Q&A: Standard Angle for A-Frame Trailer Tongue for Coupler Replacement
- Q&A: Recommendation For Replacing A Dayton Fayette 9222 Hub
Kyle S.
4/2/2024
Thanks so much!