Measurement for Locating Ball Hole in Truck Bed of 2012 Ram 3500 for Install of B and W Gooseneck
Question:
Hello, can you tell me where to drill the hole for the turnover hitch on a 2012 Ram 3500 mega cab dually? I have seen a couple of videos stating 45 1/2 inches. I downloaded pdf instructions and they say that for anything other than a long bed it should be 44 1/4 from the rear of the bed. Can you verify the correct location for me please? Thanks
asked by: Tommy R
Expert Reply:
Hey Tommy, for the B and W Turnoverball part # BWGNRK1313 that fits your 2012 Ram 3500 short bed you would need to use the measurement of 45-1/2 inches which is listed in the install instructions I attached to this page. This will be from the rear edge of the truck bed forward and it will be where the center of the 4 inch hole should be.
Products Referenced in This Question
B&W Turnoverball Underbed Gooseneck Trailer Hitch w/ Custom Installation Kit - 30,000 lbs
- Gooseneck Hitch
- Below the Bed
- Manual Ball Removal
- 7500 lbs TW
- 30000 lbs GTW
- Removable Ball - Stores in Hitch
- Wheel Well Release
- 2-5/16 Hitch Ball
- B and W
more information >
Product Page this Question was Asked From
B&W Companion 5th Wheel Trailer Hitch w/ Slider - Dual Jaw - 20,000 lbs
- Fifth Wheel Hitch
- Sliding Fifth Wheel
- Aftermarket Below Bed Rails
- 5000 lbs Vertical Load
- 20000 lbs GTW
- Double Pivot
- Standard - Double Jaw
- 17 - 19 Inch Tall
- 12 Inch Fore/Aft Travel
- B and W
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Does Truck with 6-1/2 ft bed Have to Use Slider Hitch for Turning Clearance with Fifth Wheel Hitch
- Q&A: Replacement RV ladder for 2007 Monaco Diplomat
- Article: Gooseneck to 5th Wheel Adapters
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Is Bow in 3,500 lb Trailer Axle Enough Camber for Loaded and Unloaded Trailers
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Recommended RV Exterior Ladder for 22 Ft Thor Four Winds RV
- Q&A: What is the Difference Between 7-Way RV and Utility Trailer Connectors
- Q&A: How Far Back Should Thule Mounting Feet Be Placed On a 2019 Toyota Highlander with Bare Roof
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
Tommy
3/31/2024
Thanks. The part number that I have is GRNM1307, and GNRC907. My truck is a 2012 3500 Mega Cab.