What Holds The LED Step and Accent Light # TN92VR In Place?
Question:
watched video on lights but not sure what holds light tight on side of rv
asked by: Rick J
0
Expert Reply:
The LED Step and Accent Light # TN92VR is designed to fit a 3/4" hole with the included grommet. The grommet will fit into the hole and then the light pushes into the grommet. With the light in place it prevents the rubber grommet from sliding out. I have included another video near the bottom of the page showing the installation for a similar Light # MCL10AKB on a utility trailer.
expert reply by:
Bud M
0
Products Referenced in This Question
LED Trailer Mini Clearance and Side Marker Light with Grommet - Submersible - 1 Diode - Amber Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Side Marker
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 3/4 Inch Diameter
- Amber
- Optronics
more information >
Product Page this Question was Asked From
LED Step and Accent Light - Recessed Mount - 1 Diode - Black Cover - White LED - Clear Lens
- Boat Lights
- Accent Lights
- Cabinets
- Countertops
- Steps
- Walkway
- Black Housing
- Recessed Mount
- LED Light
- White
- TecNiq
more information >
Continue Researching
- Q&A: Replacement 12v RV Puck Light for Sunlink RSBF3NN-008
- Q&A: Can High Pointe EM925RYS Microwave Be Replaced with High Pointe EM925AQR
- Q&A: Replacement Lamp for Glo-Brite 410 on 2018 Tiffin Motorhome
- Q&A: Greystone Fireplace WF2613R Replacement for RV
- Q&A: Recommended Lights To Illuminate Bed On 2 Level Utility Trailer
- Q&A: Is There A Round Utility Light With Grommet That Has A Color Temp Of 5000k?
- Q&A: Porch Light Recommendation for Use on Vanagon RV
- Article: Stability Control for Heavy Duty Vehicles
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs