4 Wire Flat to 5 Wire Flat Adapter Recommendation for Towing a Trailer with Surge Brakes
Question:
We recently purchased a boat with a brake-assist trailer. Our truck, a 2000 Toyota Tundra, has what I believe to be a 4 wire flat. Our boat has a 5 wire plug. Would adapter #20036 work for the Tundra? If so, I assume I would wire the adapter to the reverse light wire. If so, I assume I would use the splice connector to connect to the red wire with blue line. I tried unsuccessfully to attach photos of the 4 wire flat on the truck, the 5 wire plug on the boat, and the reverse light wire. I would be glad to send them via email. Any and all advice would be appreciated very much.
asked by: Matthew S
Expert Reply:
You are totally on the right track. The Adapter 4 Pole to 5 Pole Trailer Wiring Adapter # 20036 that you referenced would be the correct part to use to convert your 4-way to a 5-way to activate the reverse lockout solenoid of your trailer with surge brakes.
You would install it exactly like how you described by locating your reverse light circuit and then using the included quick-splice connector to tap the blue wire from the # 20036 into it.
Your pictures did make it through also and thank for them as it makes my job easier!
I attached an install video for this product for you to check out also.
Product Page this Question was Asked From
Tow Ready 4 Pole to 5 Pole Trailer Wiring Adapter
- Trailer Wiring
- Wiring Adapters
- Single-Function Adapter
- 0 - 5 Feet Long
- 4 Flat
- Plug and Lead
- 5 Flat
- Tow Ready
more information >
Continue Researching
- Shop: Tow Ready 4 Pole to 5 Pole Trailer Wiring Adapter
- Shop: Trailer Wiring
- Video: Trailer Wiring Harness Installation - 2006 Kia Sedona 20036
- Shop: Curt Trailer Connector Adapter - 4-Way Flat to 5-Way Flat - Vehicle End
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Fenders for 14 Diameter Wheels on Boat Trailer
- Search Results: 20036
- Video: Demco Hydraulic Brake Actuator Reverse Lockout Solenoid Installation
- Video: Tow Ready Wiring - Wiring Adapters - 20036 Review
- Shop: Curt Vehicle Wiring Harness with 5-Pole Flat Trailer Connector - 60" Wire Lead
- Shop: CE Smith Single Axle Trailer Fenders w/ Top and Side Steps - Black Plastic - 14" Wheels - Qty 2
- Shop: Vehicle Tow Bar Wiring
- Video: Curt 4-Way Flat to 5-Way Flat Trailer Connector Adapter Installation - 2010 Acura MDX
- Shop: Karrier ST225/75R15 Radial Tire with 15" White Spoke Wheel - 6 on 5-1/2" - Load Range E
- Shop: Air Lift 1000 Air Helper Springs for Coil Springs - Rear
- Shop: Dexter Trailer Idler Hub for 6,000-lb Axles - 6 on 5-1/2" - Galvanized
- Video: Tow Ready 4 Pole to 5 Pole Trailer Wiring Adapter Installation - 2015 Toyota Highlander
- Video: Trailer Wiring Harness Adapter Installation - 2007 Hyundai Entourage
- Video: Tow Ready 4 Pole to 5 Pole Trailer Wiring Adapter Installation - 2009 Nissan Xterra
- Search Results: trailer hub
- Search Results: 15 inch wheel
- Search Results: lug
- Search Results: 4 to 5 pin flat adapter
- Search Results: 7 pin to 4 pin led
- Search Results: hub
- Q&A: 5-Way Adapter Recommendation to Allow Trailer with Surge Brakes Backup
- Shop: Brake Controller
- Shop: Suspension Enhancement
- Q&A: How to Tap into Reverse Light Circuit for Lockout on Surge Brake Trailer for 2016 Toyota Highlander
- Q&A: Choosing Between Kenda Karrier and Kenda Loadstar ST175/80-13 Tire