Will The Kat's Heaters Ether Start Fluid Injection System Work Without Hooking Into The Thermostat
Question:
I would like to install the kats ether system on my jeep. Will it work if I don’t wire in the thermostat. I want it to spray in warmer weather also.
asked by: Danny P
0
Expert Reply:
Yes, the Kat's Heaters Ether Start Fluid Injection System # KH33210 would still work if you didn't hook into the thermostat and would spray ether on each startup instead of only when the temperature hits below 50 degrees.
expert reply by:
Kevin C
0
Product Page this Question was Asked From
Kat's Heaters Ether Start Fluid Injection System - 1.6L to 3.3L Engine - 12V - 18 oz - Automatic
- Vehicle Heaters
- Fluid Injection Starter
- Automatic Operation
- 12 Volts
- 18 Oz Fuel Cylinder
- 100 - 199 CID Engine
- Kats Heaters
more information >
Continue Researching
- Q&A: Where to Install Block Heater on a 2011 Hyundai Elantra
- Q&A: Why Is the Inno Tire Hold 2 Not Compatible with a Motorhome?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Is There a 2 Inch Trailer Hitch Receiver For 2022 Mazda CX-9
- Q&A: How to Torque Hitch Ball When Installing into Ball Mount
- Q&A: Torque Specs for 1-7/8-Inch Hitch Balls with 3/4-Inch and 1-Inch Shanks
- Q&A: Recommended Tightening Torque for Hitch Mounting Bolts
- Q&A: What is the Recommended Ball Mount for Draw-Tite Trailer Hitch, # 36297
- Article: Brake Controller Installation on a Ford Super Duty Truck (2005-2007)
- Article: Performance Chips and Modules
- Article: Brake Controller Installation: Starting from Scratch
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Replacement Automotive Lighting
- Article: My Trailer Hitch Doesn't Fit