Parts Needed to Install the Prodigy P3 Brake Controller on a 2024 Honda Pilot

Question

Question:

What do I need to connect my Prodigy P3 controller from Tekonsha on my 2024 Pilot?

asked by: Mark

0

Expert Reply:

The parts needed to install the Prodigy P3 # 90195 on your 2024 Honda Pilot all depends on if you have the factory tow package or not:

With Factory Tow Package
- Wiring Adapter # 3070-P

Without Factory Tow Package
- Curt Powered Wiring Kit # C59496
- Universal Wiring Kit # ETBC7

If you have the tow package then all you have to do is plug in the adapter under your dash and then into the back of the P3 and you're good to go, otherwise you'll have to splice in the wiring kits I referenced above to get everything in place for the controller.

expert reply by: Jon G

0

Answer 1

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 2

The P3 brake controller, #90195, will go into a sort of sleep mode after it detects no movement for 15 minutes. While it is on it does not draw very much power. What you can do to make sure it goes to sleep is exit the truck after turning it off,…

view full answer...

Answer 3

You do have the option to utilize the air brakes on your 2023 Freightliner Cascadia to control electric trailer brakes using the Hayes Air Actuated Trailer Brake Controller, part #HA100400C. However, we mostly recommend just using an electric brake…

view full answer...

Answer 4

Hey HPA, I would go with the Air Lift kit part #AL64VJ that fits your 2019 Toyota RAV4 based on what you described and your needs. This gives you adjustable support that you can tailor as needed so that you get the exact amount of support you need…

view full answer...

Answer 5

To install the Tekonsha Prodigy P3 Trailer Brake Controller #90195 in your Freightliner S2RV chassis the wiring is behind the kick panel in the drivers compartment. There is not a connector on the wires, they are simply terminated with tape. You will…

view full answer...

Answer 6

Sure thing, I will go ahead and list out what you need for your 2023 Kia Sportage to add a 7-way for a brake controller so you can tow with the Curt Trailer Hitch Receiver #C94WR: - T-Connector Vehicle Wiring Harness with 4-Way Flat Trailer Connector…

view full answer...

Answer 7

The trailer brakes work on a separate circuit than the lights. You have a couple of options to control the electric brakes on the trailer. One option is to use an air over electric brake control, #HA100400C. This unit connects to the air brakes on…

view full answer...