Recommended 5,000lb Topwind Trailer Jack Replacement

Question

Question:

i need a a frame trailer jack 5000 lb with a retract height of 8 inches top lift handle?

asked by: Robert T

0

Expert Reply:

The Buyers Products A-Frame Jack w/ Support Foot # 3370091265 is going to be the best bolt-on option based on your requirements. This topwind jack has a 5,000lb capacity and up to 15" of travel so you'll have almost twice as much travel as you need. It also comes with a rectangular foot plate that easily pins in place to spread the weight a bit more evenly. Since the footplate uses a simple pin and clip you can also swap it out with a wheel or drop leg to fit your needs.

expert reply by: Kevin C

0

Answer 1

There is a suggested and common method for 6 function trailer wiring. You will have the following functions: Right Turn, Left Turn, Ground, Tail/marker, Brake, Battery. I have included a help article on trailer wiring that includes a diagram and…

view full answer...

Answer 2

The factory trailer brake controller port on your 2021 Chevrolet Tahoe is located underneath the dash just to the left of the steering wheel. It will be taped to another harness so it may take a bit of looking to find. Keep in mind that if your Tahoe…

view full answer...

Answer 3

I do have an option for you but we have not yet gotten out hands on a 2019 Chevrolet Blazer therefore, have not had the chance to look for the brake controller wiring port either. I checked with both Tekonsha and Curt and it looks like they have not…

view full answer...

Answer 4

If your 2022 Chevrolet Tahoe does not have the factory tow package then the plug may not be there. If this is the case you would need to hardwire in a brake controller. If your Tahoe does have the tow package then the plug will be under the dash. The…

view full answer...

Answer 5

The Flint Hill Goods Square LED Brake Light Hitch Cover for 2" Hitches #FHG72VR would indeed be compatible with the #118384 on your 2012 Chevy Colorado. Using the turn signals will not cause the hitch cover to blink. The cover will light when…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Hey Philip so while we don't carry the exact spring you are looking for it does match the specs of the #e59SR so this would be a great solution. It's correct length at 23-1/8 inches and is for a 3,500 lb trailer axle like you have as well.

view full answer...

Answer 8

I looked through all of our available manual A-Frame trailer jacks and the option with the shortest retracted bracket height is the etrailer.com A-Frame #TJA-2001-B. The retracted bracket height is right at 5-1/8 inches from the ground and it has a…

view full answer...

Answer 9

I looked up your trailer and it has a standard A-frame so for a jack that will fit that we have the #TJA-2001-B which would work great. It has a retracted height from the bottom of it's bracket of 5-1/8 inches which will work great for low…

view full answer...

Recommended 5,000lb Topwind Trailer Jack Replacement

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching