Is it Possible To Switch Hubs on a Axle With 4 on 4-1/2" Bolt Pattern to a 4 on 4" Bolt Pattern?
Question:
Yes I have an older boat trailer for a 14 ft Jon boat, it has a 4 on 4 and a half lug pattern and I’m not able to find rims for it. Would I be able to change just the hub assembly to a 4 on 4 or would I have to change the whole axle ? Thanks
asked by: Shawn B
Expert Reply:
Depending on your axle spindle you may be able to change your existing 4 on 4-1/2" hub to a 4 on 4" hub. We have a hub kit for a 1" BT8 Spindle # AKIHUB-440-2-EZ-1K or a 1-1/16" BTR Spindle # AKIHUB-440-2-EZ-2K. If you can provide me with either the serial number off your axle or the bearings used on your hubs I can verify if either of these will work. Otherwise I will need to know the width of your axle hub face and the spring center measurement to verify if we have a replacement axle you can use.
Products Referenced in This Question
Easy Grease Trailer Idler Hub Assembly for 2K Axles - 4 on 4 - L44649 Bearings - Pre-Greased
- Trailer Hubs and Drums
- Hub
- Easy Grease
- EZ Lube
- Pre-Greased
- L44649
- L44649
- For 2000 lbs Axles
- 1/2 Inch Stud
- 4 on 4 Inch
- 8 Inch Wheel
- 10 Inch Wheel
- 12 Inch Wheel
- 13 Inch Wheel
- 14 Inch Wheel
- etrailer
more information >
Product Page this Question was Asked From
Easy Grease Trailer Idler Hub Assembly for 2K Axles - 4 on 4 - Pre-Greased
- Trailer Hubs and Drums
- Hub
- Easy Grease
- EZ Lube
- L44643
- L44643
- For 2000 lbs Axles
- 1/2 Inch Stud
- 4 on 4 Inch
- 8 Inch Wheel
- 10 Inch Wheel
- 12 Inch Wheel
- 13 Inch Wheel
- 14 Inch Wheel
- etrailer
more information >
Continue Researching
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Trailer Tire Sizing
- Article: Most Popular Wheel Bearings
- Q&A: How to Tell if Trailer has a BT8 or BTR Spindle Installed
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Q&A: 4-Way Trailer Wiring Recommendation for 1993 Ford E-350 Van
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Measuring For Replacement Idler Hubs On a 1997 Scamper 23L Pop Up Camper
- Q&A: What is Difference Between Trailer Bearings L44649 vs L44643
- Q&A: What is the Difference Between Load Range B and C Trailer Tires
- Q&A: Where to Measure on Trailer Spindles to Determine Replacement Hubs
- Article: How to Measure a Trailer Axle
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: 7 Common Questions Everyone Has About Trailer Tires