Does the Replacement Sidewind Handle TJD-7000S-HD Have a 1/2" Diameter
Question:
I have a square heavy duty equipment jack that attaches to my 20 rotary mower. I have broke the handle off of the jack. It is a handle that goes into the side and the handle is 1/2 thick. Do you carry a handle and roll pin?
asked by: Monte H
0
Expert Reply:
The Replacement Sidewind Handle # TJD-7000S-HD you're looking at does have a 1/2" diameter so it could work well for you if it matches what you're needing.
I'm attaching a few dimensions photos for your reference as well!
expert reply by:
Jon G
0
Product Page this Question was Asked From
Replacement Sidewind Handle for etrailer and Ram Square, Direct Weld Jacks - 3K - 7K
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Handles and Cranks
- Sidewind
- etrailer
more information >
Continue Researching
- Shop: Replacement Sidewind Handle for etrailer and Ram Square, Direct Weld Jacks - 3K - 7K
- Video: Rebuilding the etrailer and Ram Square Jacks
- Q&A: Wheel To Replace Discontinued Lionshead Black Tiger Wheel for Camper
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Q&A: Replacement for Atwood 61101 Brake Actuator
- Q&A: Bearings For Older Trailer Hub 22834
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Correct Replacement for Dexter Hub/Drum 8-415
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: Can a 4.80-12 Trailer Tire Be Replaced with a 145/80-12
- Q&A: Diameter Of Replacement Sidewind Handle for etrailer and Ram Square, Direct Weld Jacks
- Article: How to Measure a Trailer Axle
- Article: Trailer Maintenance Schedule
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Double-Eye Trailer Suspension System Review
- Article: Printable Trailer Bolt Hole Pattern Template