What Size Screws Hold Fan Motor to Assembly on the Replacement Fan Motor Assembly Kit FVK8017-00
Question:
I need to know what size bolt/screw length, head type, length of threads, diameter and thread type/size fine or coarse thread secures the fantastic fan blade to the motor. This bolt/screw would be installed from the underside of the fan assembly from inside the RV. Thank you
asked by: Mike S
1
Helpful Expert Reply:
I spoke to my contact at Fan-Tastic and they informed me that the screws that hold the motor to the fan blades of the # FVK8017-00 are #6 32 3/8.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Replacement Fan Motor Assembly Kit for Dometic FanTastic Roof Vent Fans
- Accessories and Parts
- RV Vents and Fans
- Roof Vent
- Motor Parts
- Motor
- Dometic
more information >
Continue Researching
- Q&A: Troubleshooting A Clunking Noise Between A Fifth Wheel Hitch And Base Rails While Towing
- Q&A: Why Is 5th Wheel Trailer Clunking When Starting/Stopping with B&W Companion and MORryde Pin Box
- Q&A: Parts Needed to Tow a Trailer with a 2015 Honda Pilot
- Q&A: Trailer Hitch for a 2015 Honda Pilot
- Q&A: Installation of Hitch on Fifth Wheel Trailer
- Q&A: When Flat Towing a Vehicle How Much Tongue Weight is on the Trailer Hitch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Recommended RV Exterior Ladder for 22 Ft Thor Four Winds RV
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Best Ladder Racks
- Article: Gooseneck to 5th Wheel Adapters
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: How to Replace or Install an RV Roof Vent