Can You Use a Spray In Bedliner After Fifth Wheel Hitch Installation

Question

Question:

I already have the 5th wheel installed. Am I able to now add a spray in bed liner or will it mess up my 5th wheel and/or interfear with its function?

asked by: Chris

0

Expert Reply:

Before you have the liner sprayed in I would recommend you tape off the the fifth wheel rails so that once the liner is installed you could peel the tape off and your rails would be unaffected yet the rest of your truck bed would be protected.

expert reply by: Jameson C

0

Answer 1

There is no problem installing a fifth wheel hitch if you have a spray-on bed liner as long as the bed liner is fully cured. If you are looking into adding a spray-on bed liner to your truck, then you will want to check with the installer regarding…

view full answer...

Answer 2

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 3

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from…

view full answer...

Answer 4

On vehicles with plastic bedliners it is required that you cut out a hole in the plastic bedliner that is large enough so that the 5th wheel rails can attach directly to the bed of the truck making full metal to metal contact. You will not need to…

view full answer...

Answer 5

According to my research, a 2010 Ram 2500 with the 6.7L turbo diesel engine has a maximum towing capacity of 13,350 lbs if you have the manual transmission or 13,450 lbs if you have the automatic transmission when properly equipped. Therefore, I…

view full answer...

Answer 6

If you are just looking for a new converter, the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers part #PD4635V will be a direct upgrade for the Magnetek Converter Series 6300 Model 6332 that you have now.

view full answer...

Answer 7

The Demco Channel Only Trailer Actuator, part #DM8202022, was designed to be used with drum brake applications only. You could use this actuator with disc brakes, but you would have to replace the master cylinder in the actuator with the Demco disc…

view full answer...

Answer 8

The Adco SFS AquaShed Truck Camper Cover part #290-12264 is what I recommend for your Lance Truck Bed Camper Model 1010. The Adco SFS AquaShed is durable, has zippered panels for access inside, and has weighted buckles to help with installation. The…

view full answer...

Answer 9

Trailer tires and wheels do not typically come balanced from the factory like what you see with standard passenger vehicle tires. This isn't usually needed for trailer tires and most car shops don't have the needed setup to properly balance…

view full answer...

Answer 10

For the factory brake controller on your 2017 Chevy Silverado 1500, the factory brake controller will install to the same location as an aftermarket wiring harness like #3016. The black box to the left of your brake pedal is the location with the…

view full answer...

Can You Use a Spray In Bedliner After Fifth Wheel Hitch Installation

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching