Hole Size and Door Thickness Required to Install Junior Locking Stainless Steel Flush Door Latch
Question:
Will this fit a 2006 gulf stream caralier travel trailer
asked by: Virgil R
0
Expert Reply:
The Junior Locking Stainless Steel Flush Door Latch # L1883 mounts in a 2-5/8 inch tall x 3-3/4 inch wide hole and the door will have to be no thicker than 7/8 of an inch to work. You will need to measure the door thickness on your trailer and make sure that you can cut a hole to the proper dimensions for the handle.
expert reply by:
Michael H
0
Product Page this Question was Asked From
"Junior" Locking Stainless Steel Flush Door Latch
- Trailer Door Latch
- Latches
- Flush Latch
- Stainless Steel
- Built In Lock
- 2-3/4 x 3-3/4 Inch Cutout
- Redline
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Which Brakes to Fit in Dexter 8-247 Hub and Drums
- Q&A: Wheel and Tire Recommendation For Jet Ski Trailer with Tire Size ST175/80R13
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Q&A: Replacement Clearance Lights Needed for GLO-BRITE 122R and 122Y Lights
- Q&A: Replacement Kwikee Step Controller for Part 1800709 on 2017 Thor Windsport
- Q&A: How Long Does it Take to Install Roadmaster Base Plate Kit
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Where to Position the Trailer Axle?
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Replacing Trailer Actuator Buddy 32220 Reverse Solenoid on Triton Bass Boat Trailer
- Article: Car Camping Checklist
- Article: Will Flat Towing Blow Up Your Transmission?