Inner Diameter of the 1.98" Dee Maxx Stainless Steel Drive-In Grease Cap w/ Plug

Question

Question:

What is the inner dimension of this cap?

asked by: Robb F

0

Expert Reply:

The inner diameter of the Stainless Steel Drive-In Grease Cap w/ Plug # DE69YR measures 1-7/8" (see attached).

expert reply by: Jon G

0

Inner Diameter of 1.98" Dee Maxx Stainless Steel Drive-In Grease Cap
(click to enlarge)

Answer 1

I wish we offered a grease seal that has the correct inner diameter for your spindle and would fit the hub you referenced but nothing we offer matches that. You seem to have a spindle with the bearing surfaces of a BTR (1.06 inch) and the grease seal…

view full answer...

Answer 2

The Loadstar ST205/75D14 Bias Trailer Tire with 14" Galvanized Wheel - 5 on 4-1/2 - Load Range C Item #AM3S450, is a galvanized wheel which will be the best option for your situation. I have attached a video for you to check out.

view full answer...

Answer 3

It isn't likely you have a 7 inch wheel rim. It is likely a 6 inch or a 5-1/2 inch width but that isn't an issue because they have a zero offset so the same size tire will still run exactly the same. If you want the combination the Loadstar…

view full answer...

Answer 4

Although the Dexstar Steel Mini Mod Trailer Wheel #AM20315 has a e-coat primer and black powder coat finish, this is option is much more prone to rust over an aluminum or galvanized rim. The powder coat finish is mainly for common trailer use so it…

view full answer...

Answer 5

The only repair kit we have for your Profile 2000 hand winch is the Winch Ratchet Repair Kit by Dutton-Lainson item #DL70475. If this isn't what you are needing you will have to replace your winch. I recommend the Dutton-Lainson Hand Winch -…

view full answer...

Answer 6

Yes, the Electric Trailer Brake Kit - Self-Adjusting #AKEBRK-35-SA that you referenced are an exact replacement for the AxleTek assemblies you have now that have Axletek-10-GG stamped on them. If you check out the attached picture you can see the…

view full answer...

Answer 7

Thank you for all of the info. The correct replacement bearings would be the part #TMK79FR and #TMK29FR which are both USA made Timken bearings.

view full answer...

Answer 8

Thank you for all of the photos and information! From what I can see it looks like you have a #84 spindle but that inner bearing blew out so you should be able to remove that inner sleeve that looks like it's still on the spindle (next to where…

view full answer...

Answer 9

For the Timbren Heavy-Duty Axle-Less Trailer Suspension - 4" Lift Spindle - Regular Tires - 2,000 lbs #ASR2KHDS04, I've attached a photo with all the dimensions you were seeking but the basic plate dimensions are 4-3/4 inches by 13 inches…

view full answer...

Answer 10

There is an option for one of these systems with a rise, but there isn't an axle riser kit for the Timbren Axle-Less Trailer Suspension System - 2,000 lbs #ASR2000S01. Reason for that is since these aren't a thru-axle and mount right to the…

view full answer...

Answer 11

To get the best braking power for your boat trailer you would want to have disc brakes on both axles. If you happen to be limited to one axle then you would want the rear outfitted. With a 5,000lb boat you likely have two 3,500lb torsion axles. The…

view full answer...