Display on P3 Won't Change
Question:
Teksonsha p3 display only in red cannot change
asked by: Wesley L
0
Expert Reply:
Thank you for your purchase directly from etrailer of the Tekonsha Prodigy P3 Trailer Brake Controller # 90195. If the display won't change from red, try doing a factory reset by unplugging it from power for at least 20 minutes then plugging it back in. If that fails you'll need to replace the controller via its lifetime warranty.
expert reply by:
Kyle S
0
Product Page this Question was Asked From
Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LCD Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Choose the Right Trailer Hitch Class
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Trailer Suspension Hanger Kit for Slipper Springs and 38 inch Wheelbase
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Troubleshooting A Clunking Noise Between A Fifth Wheel Hitch And Base Rails While Towing
- Q&A: Why Is 5th Wheel Trailer Clunking When Starting/Stopping with B&W Companion and MORryde Pin Box
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Q&A: What is the Difference Between the Tekonsha Prodigy P2 and the P3 Brake Controllers
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Q&A: Recommended Dexter Suspension Kit 7753400