Replacement Door Lock For Horse Trailer

Question

Question:

I have a 1996 Sidekick 3 horse slant. The tack room door latch has been replaced, but not well. I would like to put something in that looks a little tighter. I enclosed photos- the chrome one is on the escape door. Thank you

asked by: Marybeth C

0

Expert Reply:

Thanks for the photo. We only have one door lock for a horse trailer with a paddle on the right like in the photo, the Bauer Products Manger Door Lock for Horse Trailers # BA83FR.

This will fit so long as your door's cut out is 2-3/4" wide x 3-3/4" tall.

expert reply by: Kyle S

0

Horse Trailer Door Latch
(click to enlarge)

Answer 1

The Bargman L-300 lock is no longer manufactured so a direct replacement lock is not available. The Redline Full Size Locking Steel Flush Door Latch #L3980 that you referenced has a similar handle lock design and should work nicely as a replacement.…

view full answer...

Answer 2

Yes, the H-Channel for Enclosed Trailer #36281-955 can be used for the side door frame on your enclosed trailer. It is specifically designed for building cabinets and doors on a trailer. There is also the 1/16" Thick Tube Trim for Enclosed…

view full answer...

Answer 3

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 4

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 6

I spoke to my contact at Horizon Global. He said it is acceptable to mount the Bulldog Powered-Drive Kit #BD1824200100 to the slave jack itself. He also said that if you need to switch the motor wires to make it work correctly, that would be fine, as…

view full answer...

Answer 7

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 8

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Answer 9

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 10

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Replacement Door Lock For Horse Trailer

Product Page this Question was Asked From

Continue Researching