Distance From Front And Back Holes To The Edge Of The Receiver On The Draw Tite 75210
Question:
What is the horizontal distance from the first hole to the end of the receiver like you provided for the Curt hitch?
asked by: Jason
0
Expert Reply:
I grabbed a tape measure and went out to our warehouse to measure the Draw Tite hitch # 75210. From the center of the first hole to the edge of the receiver measured 9-3/4". From the second set of holes it is 12-1/2" to the edge of the receiver. I made a drawing for you which I have included below.
expert reply by:
Jesse M
0
75210 drawing
(click to enlarge)
(click to enlarge)
Products Referenced in This Question
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 7500 lbs WD GTW
- 2 Inch Hitch
- 750 lbs WD TW
- Visible Cross Tube
- Draw-Tite
more information >
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 7500 lbs WD GTW
- 2 Inch Hitch
- 750 lbs WD TW
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Trailer Hitch for 2006 Dodge Sprinter That Fits Around Spare Tire
- Q&A: Will The Draw Tite 75210 Fit Vehicles With The Factory Step Bumper
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: How to Charge a Trailer Battery Through a 7-Way Connector
- Q&A: Is Glue or Drilling Required to Install Thule Elite Van XT Promaster Bike Rack
- Q&A: Will the Draw-Tite Hitch # 75210 fit a 2006 Dodge Sprinter with a Factory Step Bumper
- Q&A: Brake Light Hitch Cover Solution for 1-1/4 Inch Hitch Receiver
- Q&A: Is Removal of Step Bumper or Spare Tire Required For Hitch Installation on a 2006 Dodge Sprinter Van
- Article: Trailer Wiring Diagrams
- Article: Performance Chips and Modules
- Article: Brake Controller Installation: Starting from Scratch