Correct Replacement LED Light Strip for a 14' Solera Awning

Question

Question:

What light strip do I need for solera V000436372. 14’. Thank you

asked by: Brady T

0

Expert Reply:

If you just need the replacement LED strip, then you'll just need the Replacement LED Light Strip for Solera RV Awnings # LC423331 and cut it down to fit your 14' awning.

If you are wanting to add a LED strip to an awning that does not already have a strip then you'll want the LED Fabric Light Kit with Switch/Plate for Solera RV Awning with Prepflex Fabric # LC674282 instead which includes the light strip, switch and plate.

expert reply by: Bryce D

0

Answer 1

Yes, we have several options, first being the Stromberg Carlson RV at 99-1/2" T x 12" W in black, #LA-401BA. We have two Surco models, one at 84-1/2" Long, #SP502L with the other for a contoured rear wall and is…

view full answer...

Answer 2

The Stromberg Carlson RV Exterior Ladder part #LA-401BA is our best replacement exterior ladder option for a Tiffin Allegro Red Motorhome. It measures 99-1/2" tall and can be trimmed shorter if needed. That said, there is also an extension…

view full answer...

Answer 3

The Solera LED Anwing Light Kit part #LC674282 installs into a light cord sewn onto the awning fabric so if you are replacing the fabric you will need to remove the light strip from the old awning fabric and install it into the new fabric if you…

view full answer...

Answer 4

I verified with the manufacturer that the light cord/track is present in the Solera 12' Replacement Awning Fabric - White Fade #LCV000334356. This will allow you to slide in the light kit you mentioned, which is the LED Fabric Light Kit with…

view full answer...

Answer 5

I did some online research and your 2021 Keystone Montana High Country 331RL comes pre-wired for the top of the line SolarFlex system. This SolarFlex system is a 1,200 watt system with 4, 300 watt solar panels. Our comparable system is the Go Power…

view full answer...

Answer 6

For a 12 foot awning the part #LCV000334919-362241 would be exactly what you'd need and then to add an LED light kit you'd need the part #LC674282 as well and you'd be set.

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

Hey Jean-Marc, thanks for the pictures! The replacement LED Light Strip for Solera RV Awnings #LC423331 does fit the awning light strip channel you have.

view full answer...

Correct Replacement LED Light Strip for a 14' Solera Awning

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching