Troubleshooting P2 Brake Controller Pulsing Electric Over Hydraulic Actuator but Not Working
Question:
Hi I have an electric/hydraulic trailer braking system. Controller is Tekonsha P2 which by research is suitable for said application. When connected tow vehicle to trailer, controller indicates connected, . C. , ie dot C dot. A pulse about every 10 seconds is being sensed by hydraulic system operating a relay and pump momentarily. I replaced the , Tekonsha Primus IQ I had initially with same issue, but was advised not suitable for electric/hydraulic system. Any help? Thx
asked by: Ross H
Expert Reply:
It sounds like our Prodigy P2 part # 90885 isn't in hydraulic mode based on what you described. I attached a picture that covers how to do this.
Product Page this Question was Asked From
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Replacement Hub for 2013 Wildwood 26TBSS Hub Drum with AL-KO 8700
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: How To Add a Fuel Tank To a Truck with 5th Wheel Hitch In Bed
- Q&A: Recommended 16' Mesh Tarp for Dump Trailer
- Q&A: How to Bleed Electric Over Hydraulic Trailer Brakes
- Q&A: Comparing the Curt Q20 and the Curt A20 5th Wheel Hitches.
- Q&A: Which Nev-R-Adjust Brake Assemblies for Load Trail 14K Dump Trailer
- Article: Best Camper Jacks
- Article: How to Choose the Right Trailer Hitch Class
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)