Is Drilling Required for Installation of Pop & Lock Fuel Door with BOLT Lock for Jeep Wrangler
Question:
You stated in another question about the pop and lock pl3000 that drilling is required for installation, but I just watched a video where no drilling was required? You just line up the correct plastic pins in original body hole ? Which is correct ?
asked by: Chuck
0
Expert Reply:
Drilling is not required for the installation of the Pop & Lock Fuel Door with BOLT Lock for Jeep Wrangler # PL3000. The housing fits in place of what you currently have using the locator pin and presses into place. The screws are only used to attach the door to the housing.
expert reply by:
Robin H
0
Product Page this Question was Asked From
Pop & Lock Fuel Door with BOLT Lock for Jeep Wrangler JK - Black
- Vehicle Locks
- Fuel Door Lock
- Vehicle Specific
- Black
- Pop and Lock
more information >
Continue Researching
- Article: How to Choose the Best Tonneau Cover
- Q&A: Does B and W Continuum Weight Distribution Work in Cold Weather
- Q&A: Upgrading From Curt E16 to A16 on Ram 2500
- Q&A: How Does Sway Control Work on B&W Continuum Weight Distribution System 1,600 Lbs
- Q&A: Does the B&W Continuum Weight Distribution System Work w/ A Gen-Y Torsion Ball Mount?
- Q&A: Recommended Weight Distribution System for a Grand Design Momentum 31G Toy Hauler
- Q&A: How Much Does Adapter Rails for Curt 5th Wheel Hitch Ram Rail Kit Weigh
- Q&A: Proper Solera Slide Topper Tension Adjustment
- Article: Which Hitches are Made in the USA
- Article: How Much Solar Power Do I Need For My RV?
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Trailer Tire Sizing
- Article: How to Charge RV Batteries
- Article: My Trailer Hitch Doesn't Fit