What Gauge Wire Does the Dexter Nev-R-Adjust Electric Trailer Brake Kit item # 23-468-469 Use?
Question:
What size are the wires leaving the magnets on this set of brakes? If I use your recommended 10ga wire, what connectors are recommended to make the connection?
asked by: Gerry M
0
Expert Reply:
The Dexter Nev-R-Adjust Electric Trailer Brake Kit item # 23-468-469 uses 12 gauge wire. It is highly recommend to run 10 gauge wire like item # 10-1-1 from your 7-way connector.
I recommend using the Deka Heat Shrink Butt Connector item # DW05745-10 to make the connections. These connectors work with both 12 and 10 gauge wire.
expert reply by:
Jerred H
0
Products Referenced in This Question
Deka Heat Shrink Butt Connector - 12-10 Gauge - Nylon Insulation - Yellow - Qty 10
- Wiring
- Wire Connectors
- Butt Connectors
- 12-10 Gauge
- Deka
more information >
Product Page this Question was Asked From
Dexter Nev-R-Adjust Electric Trailer Brakes - 10" - Left/Right Hand Assemblies - 3.5K
- Trailer Brakes
- Electric Drum Brakes
- Standard Grade
- Self Adjust
- 10 x 2-1/4 Inch Drum
- 3500 lbs Axle
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- Dexter
more information >
Continue Researching
- Q&A: Tire and Wheel Size to Replace 18.5x8.5-8 on Trailer
- Q&A: Parts Needed To Install Solera Awning Fabric On Slide-Out
- Q&A: Replacement Fulton Winch Strap Measuring 1-7/8 Inches by 14 Feet Long
- Article: How to Charge RV Batteries
- Q&A: What Hitch Gives the Highest Ground Clearance on My 2022 Toyota Sienna?
- Article: Trailer Wiring Diagrams
- Q&A: Replacement for Atwood 70254 RV Landing Gear Switch
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Most Popular Wheel Bearings
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Availability of 7-1/2-inch-long V-Shaped Replacement Keel Roller for Boat Trailer
- Q&A: What Does Hole In Rear Hanger For 2-1/2" Wide Hanger Used For?